TL16C552A, TL16C552AM
DUAL ASYNCHRONOUS COMMUNICATIONS ELEMENT
WITH FIFO
SLLS189D – NOVEMBER 1994 – REVISED JANUARY 1999
Terminal Functions (Continued)
TERMINAL
NAME
SOUT0,
SOUT1
NO.
FN
26, 10
PN
39, 23
O
Serial data outputs. SOUT0 and SOUT1 are the serial data outputs from the ACE transmitter circuitry.
A mark is a high state and a space is a low state. Each SOUT is held in the mark condition when the
transmitter is disabled (RESET is asserted low), the transmitter register is empty, or when in the loop
mode.
Line printer strobe. STB provides communication between the TL16C552A and the printer. When STB
is active (low), it provides the printer with a signal to latch the data currently on the parallel port. STB
has an internal pullup resistor to VDD of approximately 10 kΩ.
3-state output control input. TRI controls the 3-state control of all I/O and output terminals. When TRI
is asserted, all I/Os and outputs are in the high-impedance state, allowing board level testers to drive
the outputs without overdriving internal buffers. TRI is level sensitive and is pulled down with an internal
resistor that is approximately 5 kΩ .
Transmitter ready. Two types of DMA signaling are available. Either can be selected using FCR3 when
operating in FIFO mode. Only DMA mode 0 is allowed when in TL16C450 mode. Single-transfer DMA
(a transfer is made between CPU bus cycles) is supported by mode 0. Multiple transfers that are made
continuously until the transmitter FIFO has been filled are supported by mode 1.
Mode 0. In FIFO mode (FCR0 = 1, FCR3 = 0) or in TL16C450 mode (FCR0 = 0) when there are no
characters in the transmitter holding register or transmitter FIFO, TXRDYx is active (low). Once
TXRDYx is activated (low), it goes inactive after the first character is loaded into the holding register
of the transmitter FIFO.
Mode 1. TXRDY goes active (low) in FIFO mode (FCR0 = 1) when FCR3 = 1 and there are no
characters in the transmitter FIFO. When the transmitter FIFO is completely full, TXRDY goes inactive
(high).
VDD
23, 40,
64
6, 36,
56
Power supply. The VDD requirement is 5 V
±
5%.
I/O
DESCRIPTION
STB
55
74
I/O
TRI
2
12
I
TXRDY0
TXRDY1
22, 42
35, 58
O
absolute maximum ratings over operating free-air temperature range (unless otherwise noted)
†
Supply voltage range, V
DD
(see Note 1) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . – 0.5 V to V
DD
+ 0.3 V
Input voltage range, V
I
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . – 0.5 V to 7 V
Output voltage range, V
O
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . – 0.5 V to V
DD
+ 0.3 V
Continuous total power dissipation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . See Dissipation Rating Table
Operating free-air temperature range, T
A:
: I suffix . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . – 40°C to 85°C
M suffix . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . – 55°C to 125°C
Storage temperature range, T
stg
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . – 65°C to 150°C
† Stresses beyond those listed under “absolute maximum ratings” may cause permanent damage to the device. These are stress ratings only, and
functional operation of the device at these or any other conditions beyond those indicated under “recommended operating conditions” is not
implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
NOTE 1: All voltage levels are with respect to GND.
DISSIPATION RATING TABLE‡
TA
≤
25°C
DERATING FACTOR§
TA = 70°C
POWER RATING
ABOVE TA = 25°C
POWER RATING
1730 mW
1689 mW
19.2 mW/° C
13.5 mW/° C
865 mW
1081 mW
PACKAGE
FN
HV
TA = 125°C
POWER RATING
–
337 mW
‡ Power ratings assume a maximum junction temperature (TJ) of 115° C for ’I’ and 150° C for ’M’ suffix devices.
§ Derating factor is the inverse of the junction-to-ambient thermal resistance, R
θJA
.
6
POST OFFICE BOX 655303
•
DALLAS, TEXAS 75265
TI [ TEXAS INSTRUMENTS ]
