CC2510Fx / CC2511Fx
2
Key Features (in more details)
2.1 High-Performance and Low-Power
8051-Compatible Microcontroller
• Support for µ-law compression and
expansion
• Optimized 8051 core which typically
gives 8x the performance of a standard
8051
• Typically used to connect to external
DAC or ADC
• Two data pointers
2.5 Hardware AES Encryption/Decryption
• In-circuit interactive debugging is
supported by the IAR Embedded
Workbench through a simple two-wire
serial interface
• 128-bit AES supported in hardware
coprocessor
2.6 Peripheral Features
• SW compatible with CC1110Fx/CC1111Fx
• Powerful DMA Controller
• Power On Reset/Brown-Out Detection
2.2 8/16/32 kB Non-volatile Program
Memory and 1/2/4 kB Data Memory
• ADC with eight individual input
channels, single-ended or differential
(CC2511Fx has six channels) and
configurable resolution
• 8, 16, or 32 kB of non-volatile flash
memory,
in-system
programmable
through a simple two-wire interface or
by the 8051 core
• Programmable watchdog timer
• Minimum flash memory endurance:
• Five timers: one general 16-bit timer
with DSM mode, two general 8-bit
timers, one MAC timer, and one sleep
timer
1000 write/erase cycles
• Programmable read and write lock of
portions of flash memory for software
security
• Two
programmable
USARTs
for
master/slave SPI or UART operation
• 1, 2, or 4 kB of internal SRAM
• 21 configurable general-purpose digital
I/O-pins (CC2511Fx has 19)
2.3 Full-Speed USB Controller (CC2511Fx )
• Random number generator
• 5 bi-directional endpoints in addition to
control endpoint 0
2.7 Low Power
• Full-Speed, 12 Mbps transfer rate
• Four flexible power modes for reduced
• Support for Bulk, Interrupt, and
power consumption
Isochronous endpoints
• System can wake up on external
interrupt or when the Sleep Timer
expires
• 1024 bytes of dedicated endpoint FIFO
memory
• 8 - 512 byte data packet size supported
• 0.5 µA current consumption in PM2,
where external interrupts or the Sleep
Timer can wake up the system
• Configurable FIFO size for IN and OUT
direction of endpoint
• 0.3 µA current consumption in PM3,
where external interrupts can wake up
the system
2.4 I2S Interface
• Industry standard I2S interface for
transfer of digital audio data
• Low-power fully static CMOS design
• Full duplex
• System clock source is either a high
speed crystal oscillator (24 - 27 MHz for
CC2510Fx and 48 MHz for CC2511Fx) or a
high speed RC oscillator (12 - 13.5 MHz
for CC2510Fx and 12 MHz for CC2511Fx).
• Mono and stereo support
• Configurable sample rate and sample
size
SWRS055F
Page 6 of 241
TI [ TEXAS INSTRUMENTS ]
