DS_1215F_003
73S1215F Data Sheet
START Bit
CLK
IO
Data from Card -end of ATR
Data from TX FIFO
6
RLength
Count MAX
RLen=0
Rlen=1
RLength Count - was set for length of ATR
RLength Interrupt
5
1
2
CLK Stop
CLK Stop Level
IO Bit
3
7
IODir Bit
6
TX/RX Mode Bit
TX = '1'
4
1. Interrupt generated when Rlength counter is MAX.
2. Read and clear Interrupt.
3. Set CLK Stop and CLK Stop level high in Interrupt routine.
4. Set TX/RX Bit to TX mode.
5. Reload Rlength Counter.
6. Set IO Bit low and IODir = Output. Since Rlen=(MAX or 0) and TX/RX =1, IO pin is controlled by IO bit.
7. Clear CLK Stop and CLK Stop level.
Note: Data in TX fifo should not be Empty here.
Synchronous Clock Start/Stop Mode style Start bit procedure. This procedure should be used to
generate the start bit insertion in Synchronous mode for Synchronous Clock Start/Stop Mode protocol.
Figure 23: Creation of Synchronous Clock Start/Stop Mode Start Bit in Sync Mode
STOP Bit
CLK
I2CMode = 1: Data to/from Card
I2CMode = 0: Data from TX fifo
I2CMode = 1:ACK Bit (to/from card)
I2CMode = 0: Data from TX fifo
Min ½ ETU
IO
RLength Count MAX
2
6
RLength Count
(Rlength = 9)
1
RLength Interrupt
CLK Stop
7
3
CLK Stop Level
IO Bit
4
IODir Bit
TX/RX Mode Bit
TX = '1'
5
1. Interrupt generated when Rlength counter is MAX.
2. Read and clear Interrupt.
3. Set CLK Stop and CLK Stop level high, set IO Bit low and IODir = Output.
4. Set IO Bit High and IODir = Output.
5. Set TX/RX Bit to RX mode.
6. Reload Rlength Counter.
7. Clear CLK Stop and CLK Stop level.
Synchronous Clock Start/Stop Mode Stop bit procedure. This procedure should be used to
generate the Stop bit in Synchronous Mode.
Figure 24: Creation of Synchronous Clock Start/Stop Mode Stop Bit in Sync Mode
Rev. 1.4
85
TERIDIAN [ TERIDIAN SEMICONDUCTOR CORPORATION ]
