73S1121F
EMV Smart-Card Terminal Controller
with Built-in Dual ISO-7816 Interface and USB
DATA SHEET
FEATURES
80C52 core:
12 clock-cycle / instruction
CPU clocked up to 24MHz (with a 12MHz crystal)
16-bit PC (64kB program linear memory address
space)
Memory:
64kB internal Flash (Program Memory)
128 Bytes Flash Info Memory Block
Flash memory guaranteed for 10,000 erase-write
cycles
1kB IRAM (internal RAM for registers) + 4kB
internal XRAM (User Data Memory)
Interface for external program / data memory
Boot-ROM loader program allows both In-System-
Programming and In-Application-Programming of
the embedded flash (ISP and IAP modes)
ISP programming mode and external memory
interface can be permanently disabled by protection
fuses
Oscillators:
Single low-cost 12MHz crystal
Optional low-cost 32kHz crystal (with internal
counter for RTC support)
An Internal PLL provides all the necessary clocks to
each block of the system
Interrupts:
Standard 80C52 2-priority level structure
8 different sources of interrupt
Power Down Modes:
2 standard 80C52 Power Down and IDLE modes
1 low-speed mode (CPU run at 32kHz)
Timers:
(3) Standard 80C52 timers T0, T1 and T2
(1) 16-bit timer that can generate RTC interrupts
from the 32KHz oscillator
(2) Built-in ISO-7816 card interfaces:
(2) Independent step-up converters generate VCC
for the card (3V or 5V)
Compliant with EMV 4.0 (EMV2000)
Activation/Deactivation sequencers
Auxiliary I/O lines (C4-C8 signals)
4.5kV ESD protection on all interface pins
Communication with smart cards:
ISO-7816 UART 9600 to 115kbps (with 12MHz
crystal) for protocols T=0, T=1
2-Byte FIFO for transmit and receive
Hardware support to manage additional external
card interfaces
Communication interfaces:
Full-duplex serial interface (1200 to 115kbps
UART)
USB 1.1 Full Speed 12Mbps Interface (backward
compatible with USB 2.0), PC/SC compliant with 4
Endpoints:
-
Control (16B FIFO)
-
Interrupt IN (32B FIFO)
-
Bulk IN (128B FIFO)
-
Bulk OUT (128B FIFO)
Man-Machine Interface and I/Os:
5x6 Keyboard (hardware scanning, debouching and
scrambling)
(7) Dedicated LCD I/Os (Control of any external
HD44780 standard LCD driver) – Can be also used
as standard I/Os
(8) User I/Os
(4) GPIOs (with separate voltage reference input)
Voltage Detection:
(3) Analog Inputs (Voltage detection range: 0.2V to
2.5V)
(1) 2.5V Voltage reference available on an output
pin.
Operating Voltage:
2.7V to 3.6V (3V to 3.6V when USB is in use)
Operating Temperature:
0°C to 85°C
Package:
128 pin TQFP
Bare Die
Software:
Two-level Application Programming Interface (ANSI
C-language libraries)
USB, T=0/T=1 and EMV-compliant smart card
protocol layers
PIN Management functions compatible with CCID
requirements
Page: 2 of 25
©
2005 TERIDIAN Semiconductor Corporation
Rev 2.3
TERIDIAN [ TERIDIAN SEMICONDUCTOR CORPORATION ]
