Four-Port Longitudinal Two-chip Protector
Four-Port Longitudinal Two-chip Protector
This hybrid Single In-line Package (SIP) protects four twisted pairs from overcurrent and
overvoltage conditions. Comprised of eight discrete DO-214AA SIDACtor devices and eight
TeleLink surface mount fuses, it is ideal for densely populated line cards that cannot afford
PCB inefficiencies or the use of series power resistors. Surge current ratings up to 500 A
are available.
F2
F4
Z4
F6
Z6
F8
Tip
Gnd
Ring
2
3
4
5
Tip
Gnd
Ring
7
8
9
10
Tip
12
15
Tip 17
Gnd 18
Ring 19
20
Z2
Z8
Gnd 13
Ring 14
Z1
Z3
Z5
Z7
1
6
11
16
F1
F3
F5
F7
Electrical Parameters
VDRM
VS
VDRM
Volts
VS
CO
pF
Volts
Volts
Volts
Part
Pins 2-3, 4-3, 7-8, 9-8,
Pins 2-4, 7-9,
VT
IDRM
IS
IT
IH
Pins
Number * 12-13, 14-13, 17-18, 19-18
12-14, 17-19
Volts
µAmps
mAmps
800
Amps
mAmps 2-3, 3-4
P0602Z_
P1402Z_
P1602Z_
P2202Z_
P2702Z_
P3002Z_
P3602Z_
P4202Z_
P4802Z_
P6002Z_
25
58
40
77
50
80
4
4
4
4
4
4
4
4
4
4
5
5
5
5
5
5
5
5
5
5
2.2
2.2
2.2
2.2
2.2
2.2
2.2
2.2
2.2
2.2
50
110
50
50
40
40
40
40
30
30
30
116
130
180
240
280
320
380
440
550
154
190
260
320
360
440
500
600
700
800
800
800
800
800
800
800
800
150
150
150
150
150
150
150
150
150
65
95
90
130
160
180
220
250
300
350
120
140
160
190
220
275
800
* For individual “ZA,” “ZB,” and “ZC” surge ratings, see table below.
General Notes:
•
•
•
•
•
•
•
All measurements are made at an ambient temperature of 25 °C. IPP applies to -40 °C through +85 °C temperature range.
I
PP is a repetitive surge rating and is guaranteed for the life of the product.
Listed SIDACtor devices are bi-directional. All electrical parameters and surge ratings apply to forward and reverse polarities.
V
DRM is measured at IDRM.
VS is measured at 100 V/µs.
Special voltage (VS and VDRM) and holding current (IH) requirements are available upon request.
Off-state capacitance is measured between Pins 4-3 and Pins 2-3 at 1 MHz with a 2 V bias and is a typical value for “ZA” product.
“ZB” and “ZC” capacitance is approximately 2x higher.
•
•
Device is designed to meet balance requirements of GTS 8700 and GR 974.
Lower capacitance MC versions may be available. Contact factory for further information.
Surge Ratings
IPP
IPP
IPP
IPP
IPP
ITSM
60 Hz
Amps
2x10 µs
8x20 µs
10x160 µs
10x560 µs
10x1000 µs
di/dt
Series
Amps
Amps
Amps
Amps
Amps
Amps/µs
A
B
C
150
250
500
150
250
400
90
150
200
50
100
150
45
80
100
20
30
50
500
500
500
http://www.teccor.com
+1 972-580-7777
2 - 42
© 2002 Teccor Electronics
®
SIDACtor Data Book and Design Guide
TECCOR [ TECCOR ELECTRONICS ]
