Ethernet/10BaseT/100BaseT Protector
Ethernet/10BaseT/100BaseT Protector
The DO-214AA SIDACtor Ethernet protection series is intended for applications sensitive to
load values. Typically, high speed connections require a lower capacitance. CO values are
40% lower than standard devices.
SIDACtor devices are used to enable equipment to meet various regulatory requirements
including GR 1089, ITU K.20, K.21 and K.45, IEC 60950, UL 60950, and TIA-968 (formerly
known as FCC Part 68).
Electrical Parameters
Part
VDRM
VS
VT
IDRM
IS
IT
IH
CO
pF
Number *
Volts
Volts
Volts
µAmps
mAmps
Amps
mAmps
P0642S_
P0722S_
P0902S_
P1102S_
P3002S_
58
65
75
90
280
77
88
98
130
360
4
4
4
4
4
5
5
5
5
5
800
800
800
800
800
2.2
2.2
2.2
2.2
2.2
120
120
120
120
120
25
25
25
20
15
* For surge ratings, see table below.
General Notes:
•
•
•
•
•
•
•
All measurements are made at an ambient temperature of 25 °C. IPP applies to -40 °C through +85 °C temperature range.
I
PP is a repetitive surge rating and is guaranteed for the life of the product.
Listed SIDACtor devices are bi-directional. All electrical parameters and surge ratings apply to forward and reverse polarities.
V
DRM is measured at IDRM.
VS is measured at 100 V/µs.
Special voltage (VS and VDRM) and holding current (IH) requirements are available upon request.
Off-state capacitance is measured at 1 MHz with a 2 V bias.
Surge Ratings
IPP
IPP
IPP
IPP
IPP
ITSM
60 Hz
Amps
2x10 µs
Amps
8x20 µs
Amps
10x160 µs
Amps
10x560 µs
Amps
10x1000 µs
Amps
di/dt
Series
A
B**
Amps/µs
150
250
150
250
90
150
50
100
45
80
20
30
500
500
** Contact factory for release date of B-rated devices.
http://www.teccor.com
+1 972-580-7777
2 - 14
© 2002 Teccor Electronics
®
SIDACtor Data Book and Design Guide
TECCOR [ TECCOR ELECTRONICS ]
