LM158-LM258-LM358
Absolute maximum ratings
2
Absolute maximum ratings
Table 1.
Symbol
V
CC
V
i
V
id
Supply voltage
Input voltage
Differential input voltage
Output short-circuit duation
(1)
I
in
T
oper
T
stg
T
j
Input current
(2)
Operating free-air temperature range
Storage temperature range
Maximum junction temperature
Thermal resistance junction to ambient
(3)
SO-8
MiniSO-8
TSSOP8
DIP8
Thermal resistance junction to case
SO-8
MiniSO-8
TSSOP8
DIP8
HBM: human body model
(4)
ESD
MM: machine model
(5)
CDM: charged device model
(6)
Absolute maximum ratings
Parameter
LM158,A
LM258,A
+/-16 or 32
32
32
Infinite
50
-55 to +125 -40 to +105
-65 to +150
150
125
190
120
85
40
39
37
41
300
200
1.5
0 to +70
mA
°C
°C
°C
LM358,A
Unit
V
V
V
R
thja
°C/W
R
thjc
°C/W
V
V
kV
1. Short-circuits from the output to V
CC
can cause excessive heating if V
CC
> 15 V. The maximum output
current is approximately 40 mA independent of the magnitude of V
CC
. Destructive dissipation can result
from simultaneous short-circuits on all amplifiers.
2. This input current only exists when the voltage at any of the input leads is driven negative. It is due to the
collector-base junction of the input PNP transistor becoming forward biased and thereby acting as input
diode clamps. In addition to this diode action, there is also NPN parasitic action on the IC chip. This
transistor action can cause the output voltages of the Op-amps to go to the V
CC
voltage level (or to ground
for a large overdrive) for the time during which an input is driven negative.
This is not destructive and normal output is restored for input voltages above -0.3 V.
3. Short-circuits can cause excessive heating and destructive dissipation. R
th
are typical values.
4. Human body model: A 100pF capacitor is charged to the specified voltage, then discharged through a
1.5kΩ resistor between two pins of the device. This is done for all couples of connected pin combinations
while the other pins are floating.
5. Machine model: A 200pF capacitor is charged to the specified voltage, then discharged directly between
two pins of the device with no external series resistor (internal resistor < 5Ω). This is done for all couples of
connected pin combinations while the other pins are floating.
6. Charged device model: all pins and the package are charged together to the specified voltage and then
discharged directly to the ground through only one pin. This is done for all pins.
3/19
STMICROELECTRONICS [ STMICROELECTRONICS ]
