Application hints
LIS3DH
4
Application hints
Figure 5.
LIS3DH electrical connection
ADC1 ADC2
Vdd
16
14
10µF
Vdd_IO
ADC3
1
13
9
TOP VIEW
INT1
INT2
100nF
5
8
6
Vdd_IO
Rpu
Rpu
Pull-up to be added
when I2C interface is used
GND
Digital signal from/to signal controller.Signal’s levels are defined by proper selection of Vdd_IO
The device core is supplied through Vdd line while the I/O pads are supplied through
Vdd_IO line. Power supply decoupling capacitors (100 nF ceramic, 10 µF aluminum) should
be placed as near as possible to the pin 14 of the device (common design practice).
All the voltage and ground supplies must be present at the same time to have proper
behavior of the IC (refer to Figure 5). It is possible to remove Vdd maintaining Vdd_IO
without blocking the communication bus, in this condition the measurement chain is
powered off.
The functionality of the device and the measured acceleration data is selectable and
2
2
accessible through the I C or SPI interfaces.When using the I C, CS must be tied high.
The ADC1, ADC2 & ADC3 if not used can be left floating or keep connected to Vdd or GND.
The functions, the threshold and the timing of the two interrupt pins (INT1 and INT2) can be
2
completely programmed by the user through the I C/SPI interface.
4.1
Soldering information
®
The LGA package is compliant with the ECOPACK , RoHS and “Green” standard.
It is qualified for soldering heat resistance according to JEDEC J-STD-020.
Leave “Pin 1 Indicator” unconnected during soldering.
Land pattern and soldering recommendations are available at www.st.com.
18/42
Doc ID 17530 Rev 1
STMICROELECTRONICS [ ST ]
