CY28401
Pin Description
Pin
Name
Type
Description
4,5
SRCT_IN, SRCC_IN
I,DIF 0.7V Differential SRC inputs from the clock synthesizer
O,DIF 0.7V Differential Clock Outputs
8,9,12,13,16,17,20,21,29,30, DIFT/C(7:0)
33,34,37,38,41,42
6,7,14,15,35,36,43,44
OE_(7:0)
I,SE 3.3V LVTTL active LOW input for three-stating differential
outputs
28
45
HIGH_BW#
LOCK
I,SE 3.3V LVTTL input for selecting PLL bandwidth
O,SE 3.3V LVTTL output, transitions high when PL lock is
achieved (latched output)
26
1
PWRDWN#
SRC_DIV/2#
I,SE 3.3V LVTTL input for Power-down, active LOW
I,SE 3.3V LVTTL input for selecting input frequency divided by
two, active LOW
27
23
24
46
SRC_STOP#
SCLK
I,SE 3.3V LVTTL input for SRC_Stop#, active LOW
I,SE SMBus Slave Clock Input
SDATA
IREF
I/O,OC Open collector SMBus data
I
A precision resistor is attached to this pin to set the differ-
ential output current
22
PLL/BYPASS#
VDD_A
VSS_A
VSS
I
3.3V LVTTL input for selecting fan-out or PLL operation
48
3.3V 3.3V Power Supply for PLL
GND Ground for PLL
47
3,10,18,25,32,40
2,11,19,31,39
I
I
Ground for outputs
VDD
3.3V power supply for outputs
Serial Data Interface
Data Protocol
To enhance the flexibility and function of the clock buffer, a
two-signal serial interface is provided. Through the Serial Data
Interface, various device functions, such as individual clock
output buffers, can be individually enabled or disabled. The
registers associated with the Serial Data Interface initialize to
their default setting upon power-up, and therefore use of this
interface is optional. Clock device register changes are
normally made upon system initialization, if any are required.
The interface cannot be used during system operation for
power management functions.
The clock driver serial protocol accepts byte write, byte read,
block write, and block read operations from the controller. For
block write/read operation, the bytes must be accessed in
sequential order from lowest to highest byte (most significant
bit first) with the ability to stop after any complete byte has
been transferred. For byte write and byte read operations, the
system controller can access individually indexed bytes. The
offset of the indexed byte is encoded in the command code,
as described in Table 1.
The block write and block read protocol is outlined in Table 2
while Table 3 outlines the corresponding byte write and byte
read protocol. The slave receiver address is 11011100 (DCh).
Table 1. Command Code Definition
Bit
Description
7
0 = Block read or block write operation
1 = Byte read or byte write operation
(6:0)
Byte offset for byte read or byte write operation. For block read or block write operations, these bits should be
'0000000'
Table 2. Block Read and Block Write Protocol
Block Write Protocol
Block Read Protocol
Description
Bit
1
Description
Bit
1
Start
Start
2:8
9
Slave address – 7 bits
Write = 0
2:8
9
Slave address – 7 bits
Write = 0
Rev 1.0,November 21, 2006
Page 2 of 13
SPECTRALINEAR [ SPECTRALINEAR INC ]
