Advanced I/O Controller with Motherboard GLUE Logic
Datasheet
RQM and DIO must both equal “1” before the result bytes may be read. After all the result bytes have
been read, the RQM and DIO bits switch to “1” and “0” respectively, and the CB bit is cleared, indicating
that the FDC is ready to accept the next command.
6.10 Command Set/Descriptions
Commands can be written whenever the FDC is in the command phase. Each command has a unique set
of needed parameters and status results. The FDC checks to see that the first byte is a valid command
and, if valid, proceeds with the command. If it is invalid, an interrupt is issued. The user sends a Sense
Interrupt Status command which returns an invalid command error. Refer to Table 6.16 for explanations of
the various symbols used. Table 6.17 lists the required parameters and the results associated with each
command that the FDC is capable of performing.
Table 6.16 – Description of Command Symbols
SYMBOL
NAME
DESCRIPTION
C
D
Cylinder Address The currently selected address; 0 to 255.
Data Pattern
The pattern to be written in each sector data field during formatting.
D0, D1
Drive Select 0-1 Designates which drives are perpendicular drives on the
Perpendicular Mode Command. A “1” indicates a perpendicular
drive.
DIR
Direction Control If this bit is 0, then the head will step out from the spindle during a
relative seek. If set to a 1, the head will step in toward the spindle.
DS0, DS1
Disk Drive Select
DS1
0
0
DS0
0
1
DRIVE
Drive 0
Drive 1
DTL
Special Sector
Size
By setting N to zero (00), DTL may be used to control the number of
bytes transferred in disk read/write commands. The sector size (N =
0) is set to 128. If the actual sector (on the diskette) is larger than
DTL, the remainder of the actual sector is read but is not passed to
the host during read commands; during write commands, the
remainder of the actual sector is written with all zero bytes. The CRC
check code is calculated with the actual sector. When N is not zero,
DTL has no meaning and should be set to FF HEX.
EC
EFIFO
EIS
Enable Count
Enable FIFO
When this bit is “1” the “DTL” parameter of the Verify command
becomes SC (number of sectors per track).
This active low bit when a 0, enables the FIFO. A “1” disables the
FIFO (default).
When set, a seek operation will be performed before executing any
read or write command that requires the C parameter in the
command phase. A “0” disables the implied seek.
Enable Implied
Seek
EOT
GAP
GPL
End of Track
The final sector number of the current track.
Alters Gap 2 length when using Perpendicular Mode.
Gap Length
The Gap 3 size. (Gap 3 is the space between sectors excluding the
VCO synchronization field).
H/HDS
HLT
Head Address
Selected head: 0 or 1 (disk side 0 or 1) as encoded in the sector ID
field.
Head Load Time The time interval that FDC waits after loading the head and before
initializing a read or write operation. Refer to the Specify command
for actual delays.
HUT
Head Unload
The time interval from the end of the execution phase (of a read or
write command) until the head is unloaded. Refer to the Specify
command for actual delays.
Time
Revision 1.8 SMSC/Non-SMSC Register Sets (02-24-05)
56
SMSC LPC47M182
DATASHEET
SMSC [ SMSC CORPORATION ]
