欢迎访问ic37.com |
会员登录 免费注册
发布采购

LAN91C96I-MS 参数 Datasheet PDF下载

LAN91C96I-MS图片预览
型号: LAN91C96I-MS
PDF下载: 下载PDF文件 查看货源
内容描述: 非PCI单芯片全双对象以太网控制器 [NON-PCI SINGLE-CHIP FULL DUPLES ETHERNET CONTROLLER]
分类和应用: 控制器PC以太网以太网:16GBASE-T
文件页数/大小: 110 页 / 654 K
品牌: SMSC [ SMSC CORPORATION ]
 浏览型号LAN91C96I-MS的Datasheet PDF文件第34页浏览型号LAN91C96I-MS的Datasheet PDF文件第35页浏览型号LAN91C96I-MS的Datasheet PDF文件第36页浏览型号LAN91C96I-MS的Datasheet PDF文件第37页浏览型号LAN91C96I-MS的Datasheet PDF文件第39页浏览型号LAN91C96I-MS的Datasheet PDF文件第40页浏览型号LAN91C96I-MS的Datasheet PDF文件第41页浏览型号LAN91C96I-MS的Datasheet PDF文件第42页  
Non-PCI Single-Chip Full Duplex Ethernet Controller  
LATCOL - Late collision detected on last transmit frame. If set a late collision was detected (later than 64  
byte times into the frame). When detected the transmitter JAMs and turns itself off clearing the TXENA bit  
in TCR. Cleared by setting TXENA in TCR.  
WAKEUP - When this bit is set, it indicates that a receive packet was received that had the “Magic” packet  
(MP) signature of the node’s own Individual address repetitions in it. This bit indicates a valid detection for  
magic packet.  
TX_DEFR - Transmit Deferred. When set, carrier was detected during the first 6.4 uSec of the inter frame  
gap. Cleared at the end of every packet sent.  
LTX_BRD - Last transmit frame was a broadcast. Set if frame was broadcast. Cleared at the start of every  
transmit frame.  
SQET - Signal Quality Error Test. The transmitter opens a 1.6 us window 0.8 us after transmission is  
completed and the receiver returns inactive. During this window, the transmitter expects to see the SQET  
signal from the transceiver. The absence of this signal is a 'Signal Quality Error' and is reported in this  
status bit. Transmission stops and EPH INT is set if STP_SQET is in the TCR is also set when SQET is  
set. This bit is cleared by setting TXENA high.  
16COL- 16 collisions reached. Set when 16 collisions are detected for a transmit frame. TXENA bit in TCR  
is reset. Cleared when TXENA is set high.  
LTX_MULT - Last transmit frame was a multicast. Set if frame was a multicast. Cleared at the start of  
every transmit frame.  
MULCOL - Multiple collision detected for the last transmit frame. Set when more than one collision was  
experienced. Cleared when TX_SUC is high at the end of the packet being sent.  
SNGLCOL - Single collision detected for the last transmit frame. Set when a collision is detected. Cleared  
when TX_SUC is high at the end of the packet being sent.  
TX_SUC - Last transmit was successful. Set if transmit completes without a fatal error. This bit is cleared  
by the start of a new frame transmission or when TXENA is set high.  
Fatal errors are:  
ƒ
ƒ
ƒ
ƒ
ƒ
16 collisions  
SQET fail and STP_SQET = 1  
FIFO Underrun  
Carrier lost and MON_CSN = 1  
Late collision  
Rev. 11/18/2004  
Page 38  
SMSC DS – LAN91C96I  
DATASHEET  
 复制成功!