TQFP
PIN #
BUFFER
TYPE
ALTERNATE IR PINS/MISC
ICLK
NAME
14.318
MHz Input
Clock
SYMBOL
DESCRIPTION
18
CLK14
The external connection to a single source 14.318
MHz clock.
23
24
IR Receive IRRX2
2
IR Transmit IRTX2
IS
IR Receive input
IR transmit output
O12PD
2
(Note5)
92
Drive 2/
Address X/
Interrupt
DRV2
I/OD12/
(O12/
OD12)
In PS/2 mode, this input indicates whether a second
drive is connected; DRV2 should be low if a second
drive is connected. This status is reflected in a read
of Status Register A.
Request B
nADRX
IRQ_B
Active low address decode out: used to decode a 1,
8, or 16 byte address block. (An external pull-up is
required). Refer to Configuration registers CR03,
CR08 and CR09 for more information.
The interrupt request from a logical device or IRQIN
may be output on IRQ_B. Refer to the configuration
registers for more information. If EPP or ECP Mode
is enabled, this output is pulsed low and released to
allow sharing of interrupts.
21
56
IR Mode/ IR IRMODE
Receive 3
O6/IS
I/O4
IR mode
IRR3
IR Receive 3
Power
PWRGD
This active high input indicates that the power (VCC)
is valid. For device operation PWRGD must be
active. When PWRGD is inactive, all inputs are
disconnected and put into a low power mode; all
outputs are put into high impedance. The contents af
all registers are preserved as long as VCC is valid.
The output driver current drain when PWRGD is
inactive mode drops to ISTBY - standby current.
This is the Game Port Chip Select output - active low.
It will go active when the I/O address, qualified by
AEN, matches that selected in Configuration register
CR1E.
Good/
nGame
Port Chip
Select
nGAMECS
IRQIN
96
External
Interrupt
Input
IS
This pin is used to steer an interrupt signal from an
external device onto one of eight IRQ outputs IRQA-
H.
POWER INTERFACE
13,70 Power
4,45, Ground
65,93
VCC
GND
Positive Supply Voltage.
Ground Supply.
Note 1:nRI and the UART interrupts are active when PWRGD is active and the UARTS are either fully powered or in
AUTOPOWER DOWN mode.
Note 2:The FDD output pins multiplexed in the PARALLEL PORT INTERFACE are OD drivers only and are not affected
by the FDD Output Driver Controls (see section CR05 on page 101).
Note 3:Active (push-pull) output drivers are required on these pins in the enhanced parallel port
modes.
Note 4:An external pull-up must be provided for IOCHRDY.
Note 5:The pull-down on this pin is always active including when the output driver is tristated and regardless of the state
of PWRGD.
SMSC DS – FDC37N769
Page 13 of 137
Rev. 02-16-07
DATASHEET