10 Mbps ARCNET (ANSI 878.1) Controller with 2Kx8 On-Board RAM
Datasheet
RT
RT
+VCC
+VCC
+VCC
RBIAS
RBIAS
RBIAS
75176B or
Equiv.
COM20022I 3V
COM20022I 3V
COM20022I 3V
Figure 5.8 - COM20022I 3V Network Using RS-485 Differential Transceivers
1
1
0
20MHZ
CLOCK
(FOR REF.
ONLY)
100ns
nPULSE1
100ns
nPULSE2
200ns
DIPULSE
RXIN
400ns
Figure 5.9 - Dipluse Waveform for Data of 1-1-0
In typical applications, the serial backplane is terminated at both ends and a bias is provided by the
external pull-up resistor.
The RXIN signal is directly connected to the cable via an internal Schmitt trigger. A negative pulse on this
input indicates a logic "1". Lack of pulse indicates a logic "0". For typical single-ended backplane
applications, RXIN is connected to nPULSE1 to make the serial backplane data line. A ground line (from
the coax or twisted pair) should run in parallel with the signal. For applications requiring different treatment
of the receive signal (like filtering or squelching), nPULSE1 and RXIN remain as independent pins.
SMSC COM20022I 3V
Page 27
Revision 02-27-06
DATASHEET
SMSC [ SMSC CORPORATION ]
