ST7735
9.11 Tearing Effect Output Line
The Tearing Effect output line supplies to the MPU a Panel synchronization signal. This signal can be enabled or disabled
by the Tearing Effect Line Off & On commands. The mode of the Tearing Effect signal is defined by the parameter of the
Tearing Effect Line On command. The signal can be used by the MPU to synchronize Frame Memory Writing when
displaying video images.
9.11.1 Tearing Effect Line Modes
Mode 1, the Tearing Effect Output signal consists of V-Blanking Information only:
tvdh= The LCD display is not updated from the Frame Memory
tvdl= The LCD display is updated from the Frame Memory (except Invisible Line – see above)
Mode 2, the Tearing Effect Output signal consists of V-Blanking and H-Blanking Information, there is one V-sync and 162
H-sync pulses per field.
thdh= The LCD display is not updated from the Frame Memory
thdl= The LCD display is updated from the Frame Memory (except Invisible Line – see above)
Note: During Sleep In Mode, the Tearing Output Pin is active Low.
V1.7
61
2009-12-04
SITRONIX [ SITRONIX TECHNOLOGY CO., LTD. ]
