C8051F360/1/2/3/4/5/6/7/8/9
19. UART0
UART0 is an asynchronous, full duplex serial port offering modes 1 and 3 of the standard 8051 UART.
Enhanced baud rate support allows a wide range of clock sources to generate standard baud rates (details
in Section “19.1. Enhanced Baud Rate Generation” on page 221). Received data buffering allows UART0
to start reception of a second incoming data byte before software has finished reading the previous data
byte.
UART0 has two associated SFRs: Serial Control Register 0 (SCON0) and Serial Data Buffer 0 (SBUF0).
The single SBUF0 location provides access to both transmit and receive registers. Writes to SBUF0
always access the Transmit register. Reads of SBUF0 always access the buffered Receive register;
it is not possible to read data from the Transmit register.
With UART0 interrupts enabled, an interrupt is generated each time a transmit is completed (TI0 is set in
SCON0), or a data byte has been received (RI0 is set in SCON0). The UART0 interrupt flags are not
cleared by hardware when the CPU vectors to the interrupt service routine. They must be cleared manually
by software, allowing software to determine the cause of the UART0 interrupt (transmit complete or receive
complete).
SFR Bus
Write to
SBUF
TB8
SBUF
SET
(TX Shift)
D
Q
TX
CLR
Crossbar
Zero Detector
Stop Bit
Shift
Data
Start
Tx Control
Tx Clock
Send
Tx IRQ
SCON
TI
UART Baud
Rate Generator
Serial
Port
Interrupt
Port I/O
RI
Rx IRQ
Rx Clock
Rx Control
Load
SBUF
Start
Shift
0x1FF
RB8
Input Shift Register
(9 bits)
Load SBUF
SBUF
(RX Latch)
Read
SBUF
SFR Bus
RX
Crossbar
Figure 19.1. UART0 Block Diagram
220
Rev. 1.0