欢迎访问ic37.com |
会员登录 免费注册
发布采购

SAB82525H-V21 参数 Datasheet PDF下载

SAB82525H-V21图片预览
型号: SAB82525H-V21
PDF下载: 下载PDF文件 查看货源
内容描述: 高层次的串行通信控制器扩展 [High-Level Serial Communication Controller Extended]
分类和应用: 通信控制器
文件页数/大小: 126 页 / 741 K
品牌: SIEMENS [ Siemens Semiconductor Group ]
 浏览型号SAB82525H-V21的Datasheet PDF文件第39页浏览型号SAB82525H-V21的Datasheet PDF文件第40页浏览型号SAB82525H-V21的Datasheet PDF文件第41页浏览型号SAB82525H-V21的Datasheet PDF文件第42页浏览型号SAB82525H-V21的Datasheet PDF文件第44页浏览型号SAB82525H-V21的Datasheet PDF文件第45页浏览型号SAB82525H-V21的Datasheet PDF文件第46页浏览型号SAB82525H-V21的Datasheet PDF文件第47页  
SAB 82525  
SAB 82526  
SAF 82525  
SAF 82526  
Table 4  
Special Condition Interrupts  
SPECIAL CONDITION INTERRUPTS  
Layer 2-Specific *  
Activated only if the "Auto" operating mode has been selected  
via MODE register)  
RSC  
Receive Status Change  
Activated after a status change of the opposite  
stations receiver has been detected (Receiver  
Ready/Receiver Not Ready) due to the  
reception of a  
– RR frame, if receiver was not ready, or  
– RNR frame, if receiver was ready.  
PCE  
Protocol Error  
Activated if a protocol violation has been  
detected due to the reception of  
– an S-, or I-frame with incorrect N(R),  
– an S-frame containing an I-field.  
Internal Timer  
TIN  
Timer Interrupt  
(ISTA)  
Activated if the internal timer and repeat  
counter has been expired (see description of  
TIMR register in chapter 8).  
External Pin  
CSC  
CTS Status Change  
(EXIR)  
* Only activated if enabled by setting the CIE  
bit in the CCR2 register.  
4.4 DMA Interface  
The HSCX comprises a 4-channel DMA interface for fast and effective data transfers.  
For both serial channels, a separate DMA Request Output for Transmit (DRQT) and receive  
direction (DRQR) as well as a DMA Acknowledgement (DACK) input is provided.  
The HSCX activates the DRQ line as long as data transfers are needed from/to the specific  
FIFO (level triggered demand transfer mode of DMA controller).  
It’s the responsibility of the DMA controller to perform the correct amount of bus cycles. Either  
read cycles will be performed if the DMA transfer has been requested from the receiver, or write  
cycles if DMA has been requested from the transmitter. If the DMA controller provides a DMA  
acknowledge signal (input to the HSCX’s DACK pin), each bus cycle implicitly selects the top  
of the specific FIFO and neither address (via A0-A6) nor chip select need to be supplied (I/O  
to Memory transfers). If no DACK signal is supplied, normal read/write operations (providing  
addresses) must be performed (memory to memory transfers).  
The HSCX deactivates the DRQ line immediately after the last read/write cycle of the data  
transfer has started.  
Semiconductor Group  
43  
 复制成功!