RT7272B
Operation
The RT7272B is a constant frequency, current mode
synchronous step-down converter. In normal operation,
the high sideN-MOSFET is turned on when the S-R latch
is set by the oscillator and is turned off when the current
comparator resets the S-R latch. While the high side
N-MOSFET is turned off, the low sideN-MOSFET is turned
on to conduct the inductor current until next cycle begins.
Soft-Start (SS)
An internal current source charges an internal capacitor
to build a soft-start ramp voltage. The FB voltage will track
the internal ramp voltage during soft-start interval. The
typical soft-start time is 2ms.
Current Setting
The current limit of high side MOSFET is adjustable by
an external resistor connected to the RLIM pin. The current
limit range is from 2A to 6A. When the inductor current
reaches the current limit threshold, the COMP voltage
will be clamped to limit the inductor current.
Error Amplifier
The error amplifier adjusts its output voltage by comparing
the feedback signal (VFB) with the internal 0.8V reference.
When the load current increases, it causes a drop in the
feedback voltage relative to the reference. The error
amplifier's output voltage then rises to allow higher inductor
current to match the load current.
UV Comparator
If the feedback voltage (VFB) is lower than 0.4V, the UV
Comparator will go high to turn off the high side MOSFET.
The output under voltage protection is designed to operate
in Hiccup mode. When the UV condition is removed, the
converter will resume switching.
Oscillator
The internal oscillator runs at fixed frequency 500kHz. In
short circuit condition, the frequency is reduced to 75kHz
for low power consumption.
Thermal shutdown
Internal Regulator
The over temperature protection function will shut down
the switching operation when the junction temperature
exceeds 150°C. Once the junction temperature cools
down by approximately 20°C, the converter will
automatically resume switching.
The regulator provides low voltage power to supply the
internal control circuits and the bootstrap power for high
side gate driver.
Enable
The converter is turned on when the ENpin is higher than
2V. When the ENpin is lower than 0.4V, the converter will
enter shutdown mode and reduce the supply current to
0.5μA.
Copyright 2015 Richtek Technology Corporation. All rights reserved.
©
is a registered trademark of Richtek Technology Corporation.
DS7272B-05 June 2015
www.richtek.com
3
RICHTEK [ RICHTEK TECHNOLOGY CORPORATION ]
