HIRK-315
HIRK-433
HIR6-433
RF RECEIVER DECODER HYBRID.
Mechanical Details
63.5
5
14.5
Component Side
1
3
7
11
13
15
20
25
1
2.54
Notes
Dims in mm
Pins on 0.1" pitch
Pin Dims :0.25 x 0.50 mm
Flash Programming the on board Microcontroller
The on-board microcontroller may be programmed using the circuit as below. This may be connected directly
to a PICSTART+ programmer using the In Circuit Programming Serial cable (ISPIC), please see datasheet
DS021 which describes the programming process in more detail and lists other circuit requirements.
HiRK or HiR6 Decoder Module
1
3
7
11
13
1516 17
22
25
1
2
3
4
5
6
MCLR
Data
Clock
Vcc
GND
In Circuit Serial Programmer
ICSP Connections
For more information or general enquiries, please call;
R. F. Solutions Ltd.,
Unit 21, Cliffe Industrial Estate,
South Street,
Lewes,
E Sussex, BN8 6JL. England.
Tel +44 (0)1273 898 000. Fax +44 (0)1273 480 661.
Email sales@rfsolutions.co.uk
http://www.rfsolutions.co.uk
RF Solutions is a member of the Low Power Radio Association.
Information contained in this document is believed to be accurate , however no representation or warranty is given and no liability is assumed by R.F. Solutions Ltd. with respect to the accuracy of
such information. Use of R.F.Solutions as critical components in life support systems is not authorised except with express written approval from R.F.Solutions Ltd.
DS010-6 May 06
©2006 REG No 277 4001, England.
Page 10