7.2.4
Input Pull-Up Transistors
Port 1 has built-in programmable input pull-up transistors that are available in modes 2 and 3. The
pull-up for each bit can be turned on and off individually. To turn on an input pull-up in mode 2 or
3, set the corresponding P1PCR bit to 1 and clear the corresponding P1DDR bit to 0. P1PCR is
cleared to H'00 by a reset and in hardware standby mode, turning all input pull-ups off. In software
standby mode, the previous state is maintained.
Table 7.3 indicates the states of the input pull-up transistors in each operating mode.
Table 7.3 States of Input Pull-Up Transistors (Port 1)
Mode
Reset
Off
Hardware Standby
Software Standby
Other Operating Modes
1
2
3
Off
Off
Off
Off
Off
Off
On/off
On/off
On/off
On/off
Off
Notes: Off:
The input pull-up transistor is always off.
On/off: The input pull-up transistor is on if P1PCR = 1 and P1DDR = 0, but off otherwise.
117
RENESAS [ RENESAS TECHNOLOGY CORP ]
