Standby to Manual Reset
Oscillation stops
Reset
CKIO, CKIO2*6
RESETM*1
STATUS
Normal*4
Standby*3
Reset*2
Normal*4
0 to 20 Bcyc*5
Notes: 1. When standby mode is cleared with a manual reset, the WDT does not count.
Keep RESETM low during the PLL’s oscillation settling time.
2. Reset:
HH (STATUS1 high, STATUS0 high)
3. Standby: LH (STATUS1 low, STATUS0 high)
4. Normal: LL (STATUS1 low, STATUS0 low)
5. Bcyc: Bus clock cycle
6. The CKIO2 output is available only in clock modes 0, 1, and 2.
Figure 8.6 Standby to Manual Reset STATUS Output
8.6.3
Timing for Canceling Sleep Mode
Sleep to Interrupt
Interrupt request
CKIO, CKIO2*3
STATUS
Normal*2
Sleep*1
Normal*2
Notes: 1. Sleep: HL (STATUS1 high, STATUS0 low)
2. Normal: LL (STATUS1 low, STATUS0 low)
3. The CKIO2 output is available only in clock modes 0, 1, and 2.
Figure 8.7 Sleep to Interrupt STATUS Output
Rev. 5.00, 09/03, page 196 of 760
RENESAS [ RENESAS TECHNOLOGY CORP ]
