SERIAL I/O
11.3 Clock synchronous serial I/O mode
11.3.3 Method of transmission
Figure 11.3.2 shows an initial setting example for relevant registers when transmitting. Transmission is
started when all of the following conditions (ꢀ to ꢀ) has been satisfied. When an external clock is selected,
satisfy conditions ꢀ to ꢀ with the following preconditions satisfied.
<Preconditions>
The CLK
The CLK
i
pin’s input is at “H” level (External clock selected, when the CLK polarity select bit = “0”)
pin’s input is at “L” level (External clock selected, when the CLK polarity select bit = “1”)
i
Note: When an internal clock is selected, the above preconditions are ignored.
ꢀ Transmit data is present in the UARTi transmit buffer register (transmit buffer empty flag = “0”)
ꢀ Transmission is enabled (transmit enable bit = “1”).
ꢀ The CTS
i
pin’s input is at “L” level (when the CTS function selected).
Note: When the CTS function is not selected, condition ꢀ is ignored.
By connecting the RTS
i
pin (receiver side) and CTS pin (transmitter side), the timing of transmission and
i
that of reception can be matched. For details, refer to section “11.3.6 Receive operation.”
When using interrupts, it is necessary to set the relevant registers to enable interrupts. For details, refer
to “CHAPTER 6. INTERRUPTS.”
Figure 11.3.3 shows the write operation of data after transmission start, and Figure 11.3.4 shows the detect
operation of transmit completion.
7906 Group User’s Manual Rev.2.0
11-23
RENESAS [ RENESAS TECHNOLOGY CORP ]
