HY[B/E]18L128160B[C/F]-7.5
128-Mbit Mobile-RAM
Functional DescriptionCommands
2.4.5.1
READ Burst Termination
Data from any READ burst may be truncated using the BURST TERMINATE command (see Page 34), provided
that Auto Precharge was not activated. The BURST TERMINATE latency is equal to the CAS latency, i.e. the
BURST TERMINATE command must be issued x clock cycles before the clock edge at which the last desired data
element is valid, where x equals the CAS latency for READ bursts minus 1. This is shown in Figure 18. The
BURST TERMINATE command may be used to terminate a full-page READ which does not self-terminate.
#,+
2%!$
./0
./0
"34
./0
./0
./0
./0
./0
#OMMAND
!DDRESS
"A !ꢉ
#OL N
#,ꢃꢆ
$/ N
$/ Nꢓꢅ
$/ Nꢓꢆ
$1
$1
#,ꢃꢐ
$/ N
$/ Nꢓꢅ
$/ Nꢓꢆ
ꢃ $ONgT #ARE
"A !ꢉ #OL N ꢃ "ANK !ꢉ #OLUMN N
$/ N ꢃ $ATA /UT FROM COLUMN N
"URST ,ENGTH ꢃ ꢏ IN THE CASE SHOWNꢂ
ꢆ SUBSEQUENT ELEMENTS OF $ATA /UT ARE PROVIDED IN THE PROGRAMMED ORDER FOLLOWING $/ Nꢂ 4HE
BURST IS TERMINATED AFTER THE ꢐRD DATA ELEMENTꢂ
Figure 18 Terminating a READ Burst
2.4.5.2
Clock Suspend Mode for READ Cycles
Clock suspend mode allows to extend any read burst in progress by a variable number of clock cycles. As long as
CKE is registered LOW, the following internal clock pulse(s) will be ignored and data on DQ will remain driven, as
shown in Figure 19.
Data Sheet
23
Rev. 1.71, 2007-01
05282004-NZNK-8T0D
QIMONDA [ QIMONDA AG ]
