RELEASED
PM7380 FREEDM-32P672
DATA SHEET
PMC-1990262
ISSUE 5
FRAME ENGINE AND DATA LINK MANAGER 32P672
SERRI:
The system error interrupt status bit (SERRI) reports PCI system error
interrupts to the PCI host. SERRI is set high upon detection of any address
parity error, data parity error on Special Cycle commands, reception of a
master abort or detection of a target abort event. The SERRI bit remains
valid when interrupts are disabled and may be polled to detect PCI system
error events.
PERRI:
The parity error interrupt status bit (PERRI) reports PCI parity error interrupts
to the PCI host. PERRI is set high when data parity errors are detected by
the FREEDM-32P672 while acting as a master, and when parity errors are
reported to the FREEDM-32P672 by a target via the PERRB input. The
PERRI bit remains valid when interrupts are disabled and may be polled to
detect PCI parity error events.
RFCSEI:
The receive frame check sequence error interrupt status bit (RFCSEI) reports
receive FCS error interrupts to the PCI host. RFCSEI is set high, when a
mismatch between the received FCS code and the computed CRC residue is
detected. RFCSEI remains valid when interrupts are disabled and may be
polled to detect receive FCS error events.
RABRTI:
The receive abort interrupt status bit (RABRTI) reports receive HDLC abort
interrupts to the PCI host. RABRTI is set high upon receipt of an abort code
(at least 7 contiguous 1's). RABRTI remains valid when interrupts are
disabled and may be polled to detect receive abort events.
RPFEI:
The receive packet format error interrupt status bit (RPFEI) reports receive
packet format error interrupts to the PCI host. RPFEI is set high upon receipt
of a packet that is longer than the maximum programmed length, of a packet
that is shorter than 32 bits (CRC-CCITT) or 48 bits (CRC-32), or of a packet
that is not octet aligned. RPFEI remains valid when interrupts are disabled
and may be polled to detect receive packet format error events.
RFOVRI:
The receive FIFO overrun error interrupt status bit (RFOVRI) reports receive
FIFO overrun error interrupts to the PCI host. RFOVRI is set high on
attempts to write data into the logical FIFO of a channel when it is already full.
RFOVRI remains valid when interrupts are disabled and may be polled to
detect receive FIFO overrun events.
PROPRIETARY AND CONFIDENTIAL TO PMC-SIERRA,INC., AND FOR ITS CUSTOMERS’ INTERNAL USE
97
PMC [ PMC-SIERRA, INC ]
