RELEASED
PM7350 S/UNI-DUPLEX
DATA SHEET
PMC-1980581
ISSUE 5
DUAL SERIAL LINK PHY MULTIPLEXER
Ball
Ball
Name
Type
No. Function
High Speed LVDS Links
OADDR[4]
OADDR[3]
OADDR[2]
OADDR[1]
OADDR[0]
I/O
N9 As a SCI-PHY/Utopia bus master (OMASTER = 1,
M10 0ANYPHY = 0) the OADDR[4:0] signals are used to
N10 address up to 32 PHY devices for the purposes of
L10 polling and selection for cell transfer. When
P11 conducting polling, in order to avoid bus contention,
the S/UNI-DUPLEX inserts gap cycles during which
the OADDR[4:0] bus is set to 0x1F and OAVALID is
logic 0. When this occurs, no PHY device should
drive OCA during the following clock cycle. The
polling order is based on the existence of cells in
the downstream cell buffer. The PHY device
selected for transfer is based on the OADDR[4:0]
value present during the last cycle OENB is high.
As a bus slave the OADDR[4:0] signals are inputs.
When OAVALID is sampled high in SCI-PHY/Utopia
or low in Any-PHY configuration and the sampled
OADDR[4:0] matches the OAD[4:0] bits in the
Output Address Match register, OCA is asserted if
at least one cell is available for transfer. OCA is
delayed by an additional OFCLK cycle in Any-PHY
configuration. If the OADDR[4:0] value equals the
state of the OAD[4:0] bits in the Output Address
Match register when the OENB is last sampled
high, the S/UNI-DUPLEX will initiate a cell transfer.
As a SCI-PHY/Utopia bus slave (OMASTER = 0,
OANYPHY = 0) the device must be reselected to
resume a cell transferred that has been halted by
deasserting OENB high.
The OADDR[4:0] bus is sampled or updated on the
rising edge of OFCLK.
These signals are only active if the SCIANY input is
a logic high.
PROPRIETARY AND CONFIDENTIAL TO PMC-SIERRA, INC., AND FOR ITS CUSTOMERS’ INTERNAL USE
37
PMC [ PMC-SIERRA, INC ]
