PM5363 TUPP+622
TUPP+622
DATASHEET
PMC-1981421
ISSUE 4
SONET/SDH TRIBUTARY UNIT PAYLOAD PROCESSOR FOR 622 MBIT/S
INTERFACES
Register 05H: STP VTPP #2 Configuration #1
Bit
Type
Function
Default
Bit 7
Bit 6
Bit 5
Bit 4
Bit 3
Bit 2
Bit 1
Bit 0
R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W
TUGEN
SOS
MONIS
Reserved
NOFILT
TU3
0
0
0
0
0
0
0
0
ITUG3
OTUG3
This register is used to enable the processing of STS-1 #2 (TUG3 #2) and
configure the major operational modes of VTPP #2.
OTUG3:
When set high, the OTUG3 bit configures the tributary payload processor to
process a TU3 or TUG2s that have been mapped into a TUG3 in the outgoing
data stream. When set low, the tributary payload processor defaults to
processing TUG2s that have been mapped into a VC3, or equivalently, VT
groups that have been mapped into an STS-1.
ITUG3:
When set high, the ITUG3 bit configures the tributary payload processor to
process a TU3 or TUG2s that have been mapped into a TUG3 in the
incoming data stream. When set low, the tributary payload processor defaults
to processing TUG2s that have been mapped into a VC3, or equivalently, VT
groups that have been mapped into an STS-1.
TU3:
When set high, the TU3 bit configures the tributary payload processor to
process a single TU3 that has been mapped into a TUG3. The programming
of the ITUG3 and OTUG3 bits are ignored. Both the incoming and outgoing
streams are affected simultaneously by the TU3 bit. In TU3 mode, registers
PROPRIETARY AND CONFIDENTIAL TO PMC-SIERRA, INC., AND FOR ITS CUSTOMERS’ INTERNAL USE
128