PixArt Imaging Inc.
ADNS-7530 Integrated Molded Lead-Frame DIP Sensor
Figure 7. Schematic Diagram for 3-Button Scroll Wheel Cordless Mouse Dongle
Notes
1. The supply and ground paths should be laid out using a star methodology.
2. Level shifting is required to interface a 5V micro-controller to the ADNS-7530. If a 3V micro-controller is used, the 74VHC125 component shown
may be omitted
3. All grounds MUST be correctly separated into digital and analog grounds. The digital and analog ground lines MUST be reconnected as far away as
possible at either the negative terminal of the battery or at the USB connector.
All rights strictly reserved any portion in this paper shall not be reproduced, copied or transformed to any other forms without permission.
PixArt Imaging Inc.
E-mail: fae_service@pixart.com.tw
7