PixArt Imaging Inc.
ADNS-3090 High-Performance Optical Mouse Sensor
Shutter_Max_Bound_Lower
Address: 0x1D
Access: Read/Write
Reset Value: 0x8C (before SROM download)
0x00 (after SROM download)
Bit
7
6
5
4
3
2
1
0
Field
SB
SB
SB
SB
SB
SB
SB
SB
7
6
5
4
3
2
1
0
Shutter_Max_Bound_Upper
Address: 0x1E
Access: Read/Write
Reset Value: 0x20
Bit
7
6
5
4
3
2
1
0
Field
SB
SB
SB
SB
SB
SB
SB
SB
8
15
14
13
12
11
10
9
Data Type: 16-bit unsigned integer.
USAGE: This value sets the maximum allowable shutter value when operating in automatic mode. Units are clock
cycles. Since the automatic frame rate function is based on shutter value, the value in these registers can limit the
range of the frame rate control. To read from the registers, read Upper first followed by Lower. To write to the registers,
write Lower first, followed by Upper, then execute a write to the Frame_Period_Max_Bound_Upper and Lower
registers. To set the shutter manually, disable the AGC via the Extended_Config register and write the desired value
to these registers.
Reading this register will return the most recent value that was written to it. However, the value will take effect only
after a write to the Frame_Period_Max_Bound_Upper and Lower registers. After writing to Frame_Period_Max_Bound_
Upper, wait at least two frame times before writing to Shutter_Max_Bound_Upper or Lower again. The“Busy”bit in the
Extended_Config register may be used in lieu of a timer to determine when it is safe to write. See the Extended_Config
register for more details.
In addition, the three bound registers must also follow this rule when set to non-default values:
Frame_Period_Max_Bound ≥ Frame_Period_Min_Bound + Shutter_Max_Bound.
SROM_ID
Address: 0x1F
Access: Read
Reset Value: 0x00
Bit
7
6
5
4
3
2
1
0
Field
SR
SR
SR
SR
SR
SR
SR
SR
7
6
5
4
3
2
1
0
Data Type:8-Bit unsigned integer.
USAGE: Contains the revision of the downloaded Shadow ROM firmware. If the firmware has been successfully down-
loaded and the chip is operating out of SROM, this register will contain the SROM firmware revision, otherwise it will
contain 0x00.
Note: The IC hardware revision is available by reading the Revision_ID register (register 0x01).
Reserved
Address: 0x20 – 0x3C
36
PIXART [ PIXART IMAGING INC. ]
