Philips Semiconductors
UM10206
I2C Demonstration Board 2005-1 Quick Start Guide
4. Hardware description
Microcontroller
USB Port
Remote Sensor Diode
USB Link Indicator
Expansion Connector
Fig 2. I2C Demonstration Board 2005-1
shows the following items on the hardware:
•
USB Port: port where the USB cable is plugged into the board.
•
USB_LINK LED: this green LED will illuminate when the cable is connected between
the PC and the hardware.
•
remote sensor diode: where the remote sensor diode is plugged into the board to
allow the SA56004E temperature sensor to monitor the ambient temperature.
•
microcontroller: a socketed microcontroller is provided to ensure easy service in the
event of damage to the device.
•
extension connector: this connector is used to connect future daughter cards targeting
specific Philips Semiconductors I
2
C-bus devices.
Remark:
Philips recommends connecting only daughter cards developed and provided by
Philips Semiconductors to the extension connector. Philips Semiconductors is not
responsible for damage caused by other target cards.
UM10206
© Koninklijke Philips Electronics N.V. 2006. All rights reserved.
User manual
Rev. 01 — 13 June 2006
5 of 12