Data Sheet
FS6377-01/FS6377-01g Programmable 3-PLL Clock Generator IC
10.0 Demonstration Software
Windows 3.1x/95/98-based software is available from AMI
Semiconductor that illustrates the capabilities of the
FS6377. The software can operate under Windows NT.
Contact your local sales representative or the company
directly for more information.
10.1 Software Requirements
· PC running MS Windows 3.1x or 95/98. Software
runs on Windows NT in a calculation mode only.
· 1.8MB available space on hard drive C
10.2 Software Installation Instructions
At the appropriate disk drive prompt (A:\) unzip the
compressed demo files to a directory of your choice. Run
setup.exe to install the software.
10.3 Demo Program Operation
just the calculation features of this program?" Clicking OK
starts the program for calculation only.
Launch the fs6377.exe program. Note that the parallel port
can not be accessed if your machine is running Windows
NT. A warning message will appear stating: "This version
of the demo program cannot communicate with the
FS6377 hardware when running on a Windows NT
operating system. Do you want to continue anyway, using
FS6377 demo hardware is no longer supported.
The opening screen is shown in Figure 13.
Figure 13: Opening Screen
AMI Semiconductor
www.amis.com
20
ONSEMI [ ONSEMI ]
