M58LT256JST, M58LT256JSB
Revision history
15
Revision history
Table 49. Document revision history
Date
Revision
Changes
18-Jul-2006
0.1
Initial release.
Description of CR2-CR0 011 value modified in Table 11:
Configuration Register and Note 2 added.
Table 12: Burst type definition modified.
Timings modified in Table 16: Program/erase times and endurance
cycles,.
VIO max and VDDQ max modified in Table 17: Absolute maximum
ratings.
31-Oct-2006
0.2
Values changed in Table 20: DC characteristics - currents.
VPP1 modified in Table 21: DC characteristics - voltages.
Figure 24: Erase suspend and resume flowchart and pseudocode
modified.
Appendix D: Command interface state tables modified.
Document status promoted from Target Specification to Preliminary
Data. Small text changes. Wait (WAIT) signal behavior in relation to
Output Enable modified. Section 5.4: Program status bit (SR4) and
Section 6.9: Burst length bits (CR2-CR0) modified.
Device architecture corrected (see Table 2: Bank architecture,
Figure 3: Memory map and Appendix A: Block address tables).
IDD1 and IDD6 parameter values updated in Table 20: DC
characteristics - currents. Figure 13: Synchronous burst read
suspend AC waveforms modified. tPLWL, tPLEL, tPLGL and tPLLL
values modified under Other conditions (see Table 26: Reset and
power-up AC characteristics). tELTV timing removed from Figure 11:
Synchronous burst read AC waveforms, Figure 13: Synchronous
burst read suspend AC waveforms and Table 23: Synchronous read
AC characteristics. tELTV timing modified in Table 22: Asynchronous
read AC characteristics.
18-Dec-2006
0.3
Appendix B: Common Flash interface modified.
Block Lock Down confirm (2Fh) removed from Table 47: Command
interface states - lock table, next state and Table 48: Command
interface states - lock table, next output state. Small text changes.
23-Feb-2007
27-Jun-2007
1
2
Document status promoted from Preliminary Data to full Datasheet.
Section 7.2: Synchronous burst read mode modified.
16 word boundary (wrap) feature removed from the document.
Two packing options added in Table 28: Ordering information
scheme.
Small text changes.
Changed deassertion condition in Section 7.2: Synchronous burst
read mode to state that WAIT is only de-asserted when output data
is valid. Changed TA and TBIAS minimum values in Table 17:
Absolute maximum ratings from -25 to -40.
01-Oct-2007
10-Dec-2007
3
4
Applied Numonyx branding.
107/108
NUMONYX [ NUMONYX B.V ]
