N32T1630C1C
NanoAmp Solutions, Inc.
1
Absolute Maximum Ratings
Item
Symbol
VIN,OUT
VCC
Rating
–0.2 to VCCQ+0.3
–0.2 to 4.0
500
Unit
V
Voltage on any pin relative to VSS
Voltage on VCC Supply Relative to VSS
Power Dissipation
V
PD
mW
oC
oC
oC
TSTG
Storage Temperature
–55 to 125
TA
Operating Temperature
-25 to +85
240oC, 10sec(Lead Only)
TSOLDER
Soldering Temperature and Time
1. Stresses greater than those listed above may cause permanent damage to the device. This is a stress rating only and functional
operation of the device at these or any other conditions above those indicated in the operating section of this specification is not
implied. Exposure to absolute maximum rating conditions for extended periods may affect reliability.
Operating Characteristics (Over Specified Temperature Range)
Typ1
3.0
Item
Symbol
Test Conditions
Min.
Max
Unit
VCC
VCCQ
VIH
Supply Voltage
Supply Voltage for I/O
Input High Voltage
2.7
2.7
0.8VCCQ
3.6
3.6
VCCQ+0.2
V
V
V
CC = VCCQ (Note 4)
3.0
V
VIL
Input Low Voltage
–0.2
0.4
V
VOH
VOL
ILI
IOH = 0.2mA
IOL = -0.2mA
VIN = 0 to VCC
Output High Voltage
Output Low Voltage
Input Leakage Current
Output Leakage Current
0.8VccQ
V
0.2
0.5
0.5
V
µA
µA
ILO
OE = VIH or Chip Disabled
VCC= 3.3V, VIN=CMOS levels-
Chip Enabled, IOUT = 0
Read/Write Operating Supply
ICC1
ICC2
ISB1
3.0
25.0
135.0
mA
mA
µA
Current @ 1 µs Cycle Time2
VCC= 3.3V, VIN=CMOS levels
Chip Enabled, IOUT = 0
Read/Write Operating Supply
Current @ 70 ns Cycle Time2
VCC= 3.3V, VIN=CMOS levels
Chip Disabled
Maximum Standby Current3
80
1. Typical values are measured at Vcc=Vcc Typ., TA=25°C and not 100% tested.
2. This parameter is specified with the outputs disabled to avoid external loading effects. The user must add current required to
drive output capacitance expected in the actual system.
3. This device assumes a standby mode if the chip is disabled (either CE high or both UB and LB high). In order to achieve low
standby current all inputs must be within 0.2V of either VCC or VSS
4. During testing, Vcc = VccQ.
(DOC# 14-02-005 Rev C ECN 01-0918)
The specifications of this device are subject to change without notice. For latest documentation see http://www.nanoamp.com.
3
NANOAMP [ NANOAMP SOLUTIONS, INC. ]
