MPQ4559 – 1.5A, 2MHz, 55V STEP-DOWN CONVERTER AEC-Q100 QUALIFIED
APPLICATION INFORMATION
A good rule for determining the inductance to use
is to allow the peak-to-peak ripple current in the
inductor to be approximately 30% of the
maximum switch current limit. Also, make sure
that the peak inductor current is below the
maximum switch current limit. The inductance
value can be calculated by:
COMPONENT SELECTION
Setting the Output Voltage
The output voltage is set using a resistive voltage
divider from the output voltage to FB pin. The
voltage divider divides the output voltage down to
the feedback voltage by the ratio:
R2
VOUT
VOUT
VFB=VOUT
L1=
(1-
)
R1+R2
fs ΔIL
V
IN
Thus the output voltage is:
Where VOUT is the output voltage, VIN is the input
voltage, fS is the switching frequency, and ∆IL is
the peak-to-peak inductor ripple current.
R1+R2
R2
VOUT =VFB
Choose an inductor that will not saturate under
the maximum inductor peak current. The peak
inductor current can be calculated by:
For example, the value for R2 can be 10kΩ. With
this value, R1 can be determined by:
R1=12.5(VOUT -0.8)(KΩ)
VOUT
VOUT
ILP ILOAD
1
For example, for a 3.3V output voltage, R2 is
10kΩ, and R1 is 31.6kΩ.
2 fS L1
V
IN
Where ILOAD is the load current.
Inductor
Table 1 lists a number of suitable inductors from
various manufacturers. The choice of which style
inductor to use mainly depends on the price vs.
size requirements and any EMI requirement.
The inductor is required to supply constant
current to the output load while being driven by
the switched input voltage. A larger value
inductor will result in less ripple current that will
result in lower output ripple voltage. However, the
larger value inductor will have a larger physical
size, higher series resistance, and/or lower
saturation current.
MPQ4559 Rev. 1.01
5/24/2016
www.MonolithicPower.com
MPS Proprietary Information. Patent Protected. Unauthorized Photocopy and Duplication Prohibited.
© 2016 MPS. All Rights Reserved.
11
MPS [ MONOLITHIC POWER SYSTEMS ]
