PIC18F2450/4450
REGISTER 8-3:
INTCON3: INTERRUPT CONTROL REGISTER 3
R/W-1
INT2IP
bit 7
R/W-1
U-0
—
R/W-0
R/W-0
U-0
—
R/W-0
INT2IF
R/W-0
INT1IF
INT1IP
INT2IE
INT1IE
bit 0
Legend:
R = Readable bit
-n = Value at POR
W = Writable bit
‘1’ = Bit is set
U = Unimplemented bit, read as ‘0’
‘0’ = Bit is cleared x = Bit is unknown
bit 7
bit 6
INT2IP: INT2 External Interrupt Priority bit
1= High priority
0= Low priority
INT1IP: INT1 External Interrupt Priority bit
1= High priority
0= Low priority
bit 5
bit 4
Unimplemented: Read as ‘0’
INT2IE: INT2 External Interrupt Enable bit
1= Enables the INT2 external interrupt
0= Disables the INT2 external interrupt
bit 3
INT1IE: INT1 External Interrupt Enable bit
1= Enables the INT1 external interrupt
0= Disables the INT1 external interrupt
bit 2
bit 1
Unimplemented: Read as ‘0’
INT2IF: INT2 External Interrupt Flag bit
1= The INT2 external interrupt occurred (must be cleared in software)
0= The INT2 external interrupt did not occur
bit 0
INT1IF: INT1 External Interrupt Flag bit
1= The INT1 external interrupt occurred (must be cleared in software)
0= The INT1 external interrupt did not occur
Note:
Interrupt flag bits are set when an interrupt condition occurs regardless of the state of its corresponding
enable bit or the global interrupt enable bit. User software should ensure the appropriate interrupt flag bits
are clear prior to enabling an interrupt. This feature allows for software polling.
© 2006 Microchip Technology Inc.
Advance Information
DS39760A-page 89
MICROCHIP [ MICROCHIP ]
