PIC16F631/677/685/687/689/690
Note 1: The auto-shutdown condition is
a
level-based signal, not an edge-based
signal. As long as the level is present, the
auto-shutdown will persist.
2: Writing to the ECCPASE bit is disabled
while an auto-shutdown condition
persists.
3: Once the auto-shutdown condition has
been removed and the PWM restarted
(either through firmware or auto-restart)
the PWM signal will always restart at the
beginning of the next PWM period.
FIGURE 11-14:
PWM AUTO-SHUTDOWN WITH FIRMWARE RESTART (PRSEN = 0)
PWM Period
Shutdown Event
ECCPASE bit
PWM Activity
Normal PWM
ECCPASE
Cleared by
Firmware
Start of
Shutdown
Shutdown
PWM
PWM Period
Event Occurs Event Clears
Resumes
11.4.5
AUTO-RESTART MODE
The Enhanced PWM can be configured to automati-
cally restart the PWM signal once the auto-shutdown
condition has been removed. Auto-restart is enabled by
setting the PRSEN bit in the PWM1CON register.
If auto-restart is enabled, the ECCPASE bit will remain
set as long as the auto-shutdown condition is active.
When the auto-shutdown condition is removed, the
ECCPASE bit will be cleared via hardware and normal
operation will resume.
FIGURE 11-15:
PWM AUTO-SHUTDOWN WITH AUTO-RESTART ENABLED (PRSEN = 1)
PWM Period
Shutdown Event
ECCPASE bit
PWM Activity
Normal PWM
Start of
PWM Period
Shutdown
Event Occurs Event Clears
Shutdown
PWM
Resumes
DS41262D-page 142
© 2007 Microchip Technology Inc.
MICROCHIP [ MICROCHIP ]
