PIC12F508/509/16F505
10.2 DC Characteristics: PIC12F508/509/16F505 (Extended)
Standard Operating Conditions (unless otherwise specified)
Operating Temperature -40°C ≤ TA ≤ +125°C (Extended)
DC CHARACTERISTICS
Param
Sym
No.
Characteristic
Min Typ(1) Max Units
Conditions
D001
D002
VDD
VDR
Supply Voltage
RAM Data Retention Voltage(2)
2.0
—
5.5
—
V
V
V
See Figure 10-1
1.5*
VSS
Device in Sleep mode
D003 VPOR VDD Start Voltage to ensure
—
—
See Section 7.4 "DC Character-
istics" for details
Power-on Reset
D004 SVDD VDD Rise Rate to ensure
0.05*
—
—
V/ms See Section 7.4 "DC Character-
istics" for details
Power-on Reset
D010
IDD
Supply Current(3)
—
—
—
—
170
0.4
1.7
15
TBD
TBD
TBD
TBD
μA
FOSC = 4 MHz, VDD = 2.0V(4)
mA FOSC = 10 MHz, VDD = 3.0V
mA FOSC = 20 MHz, VDD = 5.0V
μA
FOSC = 32 kHz, VDD = 2.0V, WDT
disabled
D020
IPD
Power-down Current(5)
—
—
0.1
1.0
TBD
TBD
μA
μA
VDD = 2.0V
VDD = 2.0V
D022 ΔIWDT WDT Current(5)
Legend: TBD = To Be Determined.
*
These parameters are characterized but not tested.
Note 1: Data in the Typical (“Typ”) column is based on characterization results at 25°C. This data is for design
guidance only and is not tested.
2: This is the limit to which VDD can be lowered in Sleep mode without losing RAM data.
3: The supply current is mainly a function of the operating voltage and frequency. Other factors such as bus
loading, oscillator type, bus rate, internal code execution pattern and temperature also have an impact on
the current consumption.
a) The test conditions for all IDD measurements in active operation mode are:
OSC1 = external square wave, from rail-to-rail; all I/O pins tri-stated, pulled to VSS, T0CKI = VDD,
MCLR = VDD;
WDT enabled/disabled as specified.
a) For standby current measurements, the conditions are the same, except that the device is in Sleep
mode.
4: Does not include current through REXT (in EXTRC mode only). The current through the resistor can be
estimated by the formula:
I = VDD/2REXT (mA) with REXT in kΩ.
5: The Power-down current in Sleep mode does not depend on the oscillator type. Power-down current is
measured with the part in Sleep mode, with all I/O pins in high-impedance state and tied to VDD or VSS.
DS41236C-page 70
Preliminary
© 2007 Microchip Technology Inc.