PIC16F7X7
2.2.2.2
OPTION_REG Register
Note:
To achieve a 1:1 prescaler assignment for
the TMR0 register, assign the prescaler to
the Watchdog Timer.
The OPTION_REG register is a readable and writable
register which contains various control bits to configure
the TMR0 prescaler/WDT postscaler (single assign-
able register also known as the prescaler), the external
INT interrupt, TMR0 and the weak pull-ups on PORTB.
REGISTER 2-2:
OPTION_REG: OPTION CONTROL REGISTER (ADDRESS 81h, 181h)
R/W-1
RBPU
R/W-1
R/W-1
T0CS
R/W-1
T0SE
R/W-1
PSA
R/W-1
PS2
R/W-1
PS1
R/W-1
PS0
INTEDG
bit 7
bit 0
bit 7
bit 6
bit 5
bit 4
bit 3
bit 2-0
RBPU: PORTB Pull-up Enable bit
1= PORTB pull-ups are disabled
0= PORTB pull-ups are enabled by individual port latch values
INTEDG: Interrupt Edge Select bit
1= Interrupt on rising edge of RB0/INT pin
0= Interrupt on falling edge of RB0/INT pin
T0CS: TMR0 Clock Source Select bit
1= Transition on RA4/T0CKI pin
0= Internal instruction cycle clock (CLKO)
T0SE: TMR0 Source Edge Select bit
1= Increment on high-to-low transition on RA4/T0CKI pin
0= Increment on low-to-high transition on RA4/T0CKI pin
PSA: Prescaler Assignment bit
1= Prescaler is assigned to the WDT
0= Prescaler is assigned to the Timer0 module
PS2:PS0: Prescaler Rate Select bits
Bit Value TMR0 Rate WDT Rate
000
001
010
011
100
101
110
111
1 : 1
1 : 2
1 : 4
1 : 8
1 : 16
1 : 32
1 : 64
1 : 128
1 : 2
1 : 4
1 : 8
1 : 16
1 : 32
1 : 64
1 : 128
1 : 256
Legend:
R = Readable bit
-n = Value at POR
W = Writable bit
‘1’ = Bit is set
U = Unimplemented bit, read as ‘0’
‘0’ = Bit is cleared x = Bit is unknown
DS30498C-page 22
2004 Microchip Technology Inc.
MICROCHIP [ MICROCHIP ]
