PIC16C63A/65B/73B/74B
9.1
Capture Mode
9.1.2
TIMER1 MODE SELECTION
In Capture mode, CCPR1H:CCPR1L captures the
16-bit value of the TMR1 register when an event occurs
on pin RC2/CCP1. An event is defined as one of the fol-
lowing and is configured using CCPxCON<3:0>:
•
•
•
•
Every falling edge
Every rising edge
Every 4th rising edge
Every 16th rising edge
Timer1 must be running in Timer mode or Synchro-
nized Counter mode for the CCP module to use the
capture feature. In Asynchronous Counter mode, the
capture operation may not work.
9.1.3
SOFTWARE INTERRUPT
An event is selected by control bits CCP1M3:CCP1M0
(CCP1CON<3:0>). When a capture is made, the inter-
rupt request flag bit CCP1IF (PIR1<2>) is set. The
interrupt flag must be cleared in software. If another
capture occurs before the value in register CCPR1 is
read, the previous captured value is overwritten by the
new captured value.
When the Capture mode is changed, a false capture
interrupt may be generated. The user should keep bit
CCP1IE (PIE1<2>) clear to avoid false interrupts and
should clear the flag bit CCP1IF following any such
change in operating mode.
9.1.4
CCP PRESCALER
9.1.1
CCP PIN CONFIGURATION
There are four prescaler settings, specified by bits
CCP1M3:CCP1M0. Whenever the CCP module is
turned off, or the CCP module is not in Capture mode,
the prescaler counter is cleared. Any RESET will clear
the prescaler counter.
Switching from one capture prescaler to another may
generate an interrupt. Also, the prescaler counter will
not be cleared, therefore, the first capture may be from
a non-zero prescaler. Example 9-1 shows the recom-
mended method for switching between capture pres-
calers. This example also clears the prescaler counter
and will not generate the “false” interrupt.
In Capture mode, the RC2/CCP1 pin should be config-
ured as an input by setting the TRISC<2> bit.
Note:
If the RC2/CCP1 pin is configured as an
output, a write to the port can cause a
capture condition.
FIGURE 9-1:
CAPTURE MODE
OPERATION BLOCK
DIAGRAM
Set Flag bit CCP1IF
(PIR1<2>)
EXAMPLE 9-1:
CLRF
MOVLW
CHANGING BETWEEN
CAPTURE PRESCALERS
Prescaler
÷
1, 4, 16
RC2/CCP1
pin
CCPR1H
and
Edge Detect
Capture
Enable
TMR1H
CCP1CON<3:0>
Q’s
CCPR1L
MOVWF
CCP1CON
; Turn CCP module off
NEW_CAPT_PS ; Load the W reg with
; the new prescaler
; move value and CCP ON
CCP1CON
; Load CCP1CON with this
; value
TMR1L
2000 Microchip Technology Inc.
DS30605C-page 51
MICROCHIP [ MICROCHIP TECHNOLOGY ]
