PIC16F87XA
17.2 DC Characteristics: PIC16F873A/874A/876A/877A (Industrial)
PIC16LF873A/874A/876A/877A (Industrial) (Continued)
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C ≤ TA ≤ +85°C for industrial
Operating voltage VDD range as described in DC specification
(Section 17.1)
DC CHARACTERISTICS
Param
Sym
No.
Characteristic
Min
Typ† Max Units
Conditions
VOL
VOH
Output Low Voltage
I/O ports
D080
D083
—
—
—
—
0.6
0.6
V
V
IOL = 8.5 mA, VDD = 4.5V,
-40°C to +85°C
IOL = 1.6 mA, VDD = 4.5V,
-40°C to +85°C
OSC2/CLKOUT (RC osc config)
Output High Voltage
D090
D092
I/O ports(3)
VDD - 0.7
—
—
—
—
—
V
V
V
IOH = -3.0 mA, VDD = 4.5V,
-40°C to +85°C
IOH = -1.3 mA, VDD = 4.5V,
-40°C to +85°C
OSC2/CLKOUT (RC osc config) VDD - 0.7
D150* VOD
Open-Drain High Voltage
Capacitive Loading Specs on
Output Pins
—
—
8.5
RA4 pin
D100
COSC2 OSC2 pin
—
15
pF In XT, HS and LP modes when
external clock is used to drive
OSC1
D101
D102
CIO
CB
All I/O pins and OSC2 (RC
mode) SCL, SDA (I2C mode)
Data EEPROM Memory
Endurance
—
—
—
—
50
400
pF
pF
D120
D121
ED
VDRW
100K
VMIN
1M
—
—
5.5
E/W -40°C to +85°C
V
VDD for read/write
Using EECON to read/write
VMIN = min. operating voltage
D122
TDEW
Erase/write cycle time
Program FLASH Memory
Endurance
VDD for read
VDD for erase/write
—
4
8
ms
D130
D131
D132A
EP
VPR
10K
VMIN
VMIN
100K
—
—
—
5.5
5.5
E/W -40°C to +85°C
V
V
VMIN = min operating voltage
Using EECON to read/write,
VMIN = min. operating voltage
D133
TPEW
Erase/Write cycle time
—
4
8
ms
*
These parameters are characterized but not tested.
†
Data in "Typ" column is at 5V, 25°C unless otherwise stated. These parameters are for design guidance
only and are not tested.
Note 1: In RC oscillator configuration, the OSC1/CLKIN pin is a Schmitt Trigger input. It is not recommended that the
PIC16F87XA be driven with external clock in RC mode.
2: The leakage current on the MCLR pin is strongly dependent on the applied voltage level. The specified levels
represent normal operating conditions. Higher leakage current may be measured at different input voltages.
3: Negative current is defined as current sourced by the pin.
2001 Microchip Technology Inc.
Advance Information
DS39582A-page 177