PIC16F87XA
17.1 DC Characteristics: PIC16F873A/874A/876A/877A (Industrial)
PIC16LF873A/874A/876A/877A (Industrial)
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C ≤ TA ≤ +85°C for industrial
PIC16LF873A/874A/876A/877A (Industrial)
PIC16F873A/874A/876A/877A (Industrial)
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C ≤ TA ≤ +85°C for industrial
Param Symbol
No.
Characteristic/
Device
Min
Typ† Max Units
Conditions
VDD
Supply Voltage
16LF87XA
D001
2.0
—
—
5.5
V
LP, XT, RC osc configuration
(DC to 4 MHz)
D001
16F87XA
4.0
4.5
5.5
5.5
5.5
—
V
V
V
V
LP, XT, RC osc configuration
HS osc configuration
BOR enabled, FMAX = 14 MHz(7)
D001A
VBOR
—
D002
D003
VDR
RAM Data Retention
1.5
Voltage(1)
VPOR
VDD Start Voltage to
ensure internal Power-on
Reset signal
—
VSS
—
—
V
See section on Power-on Reset for
details
D004
D005
SVDD
VBOR
VDD Rise Rate to ensure 0.05
internal Power-on Reset
signal
—
V/ms See section on Power-on Reset for
details
Brown-out Reset
Voltage
3.65
4.0
4.35
V
BODEN bit in configuration word
enabled
Legend: Rows with standard voltage device data only are shaded for improved readability.
†
Data in “Typ” column is at 5V, 25°C, unless otherwise stated. These parameters are for design guidance
only, and are not tested.
Note 1: This is the limit to which VDD can be lowered without losing RAM data.
2: The supply current is mainly a function of the operating voltage and frequency. Other factors, such as I/O
pin loading, switching rate, oscillator type, internal code execution pattern and temperature also have an
impact on the current consumption.
The test conditions for all IDD measurements in active operation mode are:
OSC1 = external square wave, from rail-to-rail; all I/O pins tri-stated, pulled to VDD;
MCLR = VDD; WDT enabled/disabled as specified.
3: The power-down current in SLEEP mode does not depend on the oscillator type. Power-down current is
measured with the part in SLEEP mode, with all I/O pins in hi-impedance state and tied to VDD and VSS.
4: For RC osc configuration, current through REXT is not included. The current through the resistor can be esti-
mated by the formula Ir = VDD/2REXT (mA) with REXT in kOhm.
5: Timer1 oscillator (when enabled) adds approximately 20 µA to the specification. This value is from charac-
terization and is for design guidance only. This is not tested.
6: The ∆ current is the additional current consumed when this peripheral is enabled. This current should be
added to the base IDD or IPD measurement.
7: When BOR is enabled, the device will operate correctly until the VBOR voltage trip point is reached.
2001 Microchip Technology Inc.
Advance Information
DS39582A-page 173