PIC16C63A/65B/73B/74B
REGISTER 11-2: RCSTA: RECEIVE STATUS AND CONTROL REGISTER (ADDRESS 18h)
R/W-0
SPEN
R/W-0
RX9
R/W-0
SREN
R/W-0
CREN
U-0
R-0
R-0
R-x
—
FERR
OERR
RX9D
bit 7
bit 0
bit 7
bit 6
bit 5
SPEN: Serial Port Enable bit
1= Serial port enabled (configures RC7/RX/DT and RC6/TX/CK pins as serial port pins)
0= Serial port disabled
RX9: 9-bit Receive Enable bit
1= Selects 9-bit reception
0= Selects 8-bit reception
SREN: Single Receive Enable bit
Asynchronous mode:
Don’t care
Synchronous mode - Master:
1= Enables single receive
0= Disables single receive
This bit is cleared after reception is complete.
Synchronous mode - Slave:
Don’t care
bit 4
CREN: Continuous Receive Enable bit
Asynchronous mode:
1= Enables continuous receive
0= Disables continuous receive
Synchronous mode:
1= Enables continuous receive until enable bit CREN is cleared (CREN overrides SREN)
0= Disables continuous receive
bit 3
bit 2
Unimplemented: Read as '0'
FERR: Framing Error bit
1= Framing error (can be updated by reading RCREG register and receive next valid byte)
0= No framing error
bit 1
bit 0
OERR: Overrun Error bit
1= Overrun error (can be cleared by clearing bit CREN)
0= No overrun error
RX9D: 9th bit of Received Data. (Can be parity bit. Calculated by firmware.)
Legend:
R = Readable bit
-n = Value at POR
W = Writable bit
U = Unimplemented bit, read as ‘0’
’0’ = Bit is cleared x = Bit is unknown
’1’ = Bit is set
DS30605C-page 66
2000 Microchip Technology Inc.
MICROCHIP [ MICROCHIP ]
