Micrel, Inc.
31
KSZ8041NL
LED1 /
Ipu/O
LED Output:
Config Mode:
Programmable LED1 Output /
SPEED
Latched as SPEED (register 0h, bit 13) during power-up / reset.
See “Strapping Options” section for details.
The LED1 pin is programmable via register 1Eh bits [15:14], and is defined as
follows.
LED mode = [00]
Speed
10BT
Pin State
LED Definition
H
L
OFF
ON
100BT
LED mode = [01]
Activity
Pin State
LED Definition
No Activity
Activity
H
L
OFF
ON
LED mode = [10]
Reserved
LED mode = [11]
Reserved
32
RST#
GND
I
Chip Reset (active low)
Ground
PADDLE
Notes:
Gnd
1. P = Power supply.
Gnd = Ground.
I = Input.
O = Output.
I/O = Bi-directional.
Ipd = Input with internal pull-down.
Ipu = Input with internal pull-up.
Opu = Output with internal pull-up.
Ipu/O = Input with internal pull-up during power-up/reset; output pin otherwise.
Ipd/O = Input with internal pull-down during power-up/reset; output pin otherwise.
2. MII Rx Mode: The RXD[3..0] bits are synchronous with RXCLK. When RXDV is asserted, RXD[3..0] presents valid data to MAC through the MII.
RXD[3..0] is invalid when RXDV is de-asserted.
3. RMII Rx Mode: The RXD[1:0] bits are synchronous with REF_CLK. For each clock period in which CRS_DV is asserted, two bits of recovered
data are sent from the PHY.
4. MII Tx Mode: The TXD[3..0] bits are synchronous with TXCLK. When TXEN is asserted, TXD[3..0] presents valid data from the MAC through
the MII. TXD[3..0] has no effect when TXEN is de-asserted.
5. RMII Tx Mode: The TXD[1:0] bits are synchronous with REF_CLK. For each clock period in which TX_EN is asserted, two bits of data are
received by the PHY from the MAC.
October 2006
11
M9999-102406-1.0
MICREL [ MICREL SEMICONDUCTOR ]
