欢迎访问ic37.com |
会员登录 免费注册
发布采购

DS1621S 参数 Datasheet PDF下载

DS1621S图片预览
型号: DS1621S
PDF下载: 下载PDF文件 查看货源
内容描述: 数字温度计和温度监控器 [Digital Thermometer and Thermostat]
分类和应用: 传感器换能器温度传感器输出元件监控
文件页数/大小: 16 页 / 332 K
品牌: MAXIM [ MAXIM INTEGRATED PRODUCTS ]
 浏览型号DS1621S的Datasheet PDF文件第1页浏览型号DS1621S的Datasheet PDF文件第2页浏览型号DS1621S的Datasheet PDF文件第3页浏览型号DS1621S的Datasheet PDF文件第4页浏览型号DS1621S的Datasheet PDF文件第6页浏览型号DS1621S的Datasheet PDF文件第7页浏览型号DS1621S的Datasheet PDF文件第8页浏览型号DS1621S的Datasheet PDF文件第9页  
DS1621
In one-shot mode, the DS1621 performs a single temperature conversion when a Start Convert T
command is issued. When the conversion is complete, the device enters a low-power idle state and
remains in that state until a single temperature conversion is again initiated by a Start Convert T
command.
Thermostat Control
In its operating mode, the DS1621 functions as a thermostat with programmable hysteresis as shown in
Figure 3. The thermostat output updates as soon as a temperature conversion is complete.
When the DS1621’s temperature meets or exceeds the value stored in the high temperature trip register
(TH), the output becomes active and will stay active until the temperature falls below the temperature
stored in the low temperature trigger register (TL). In this way, any amount of hysteresis may be
obtained.
The active state for the output is programmable by the user so that an active state may either be a logic
"1" (V
DD
) or a logic "0" (0V). This is done using the POL bit in the configuration reagister as explained
in the
Operation and Control
section of this datasheet.
Figure 3. THERMOSTAT OUTPUT OPERATION
DQ (Thermostat output, Active = High)
TL
TH
T (°C)
OPERATION AND CONTROL
The DS1621 must have temperature settings resident in the TH and TL registers for thermostatic
operation. A configuration/status register also determines the method of operation that the DS1621 will
use in a particular application, as well as indicating the status of the temperature conversion operation.
The configuration register is defined as follows:
MSb
DONE
where
DONE
= Conversion Done bit. “1” = Conversion complete, “0” = Conversion in progress.
THF
= Temperature High Flag. This bit will be set to “1” when the temperature is greater than or
equal to the value of TH. It will remain “1” until reset by writing “0” into this location or removing power
from the device. This feature provides a method of determining if the DS1621 has ever been subjected to
temperatures above TH while power has been applied.
5 of 16
Bit 6
THF
Bit5
TLF
Bit 4
NVB
Bit 3
X
Bit 2
X
Bit 1
POL
LSb
1SHOT