FIGURE 4
12V/IGNITION
SWITCH
IGNITION
MODULE
FEMALE
CONNECTOR
IGNITION BALLAST
RESISTOR
ALL WIRES NORMALLY
CONNECTED TO THE COIL
(+) TERMINAL
REFER TO MSD™ INSTRUCTIONS FOR
REMAINING POWER CONNECTIONS
MALLORY 6A, 6AL
IGNITION
and MSD
TM
6
PART NO. 6200,
SERIES IGNITION
PART
6420 or
6400,
NO. 6200,
6400, 6420 or 6462
6462
DISTRIBUTOR WIRE HARNESS
PART NO. 29349
RED
MAGNETIC PICKUP CONNECTOR NOT USED
RING TERMINAL CONNECTORS
PART NO. 450
BROWN
ENGINE
GROUND
GREEN
RED
WHITE
MSD™ 6 SERIES
BLACK
ORANGE
+
-
Installing an ignition ballast
resistor has no effect on the per-
formance of the ignition system.
However, installing or retaining
the original ignition ballast resistor
allows for easy conversion back to
standard ignition.
COIL
To prevent false triggering and possible premature ignition
failure, you must use suppression type (carbon core, spiral
core, or radio suppression core) spark plug wire.
DO NOT USE SOLID CORE (COPPER CORE OR STAINLESS
STEEL CORE) SPARK PLUG WIRE WITH ANY ELECTRONIC
IGNITION SYSTEM.
AUTOMOTIVE AND MARINE UNILITE
®
DISTRIBUTOR TUNE–UP PARTS
AUTOMOTIVE
8 CYL. (STACK CAP)
8 CYL. (FLAT CAP)
6 CYL. (37 AND 38 SERIES)
6 CYL. (45, 46 AND 47 SERIES)
4 CYL. (37 AND 38 SERIES)
4 CYL. (45, 46 AND 47 SERIES)
DISTRIBUTOR CAP
209
221
226
270
225
271
ROTOR/SHUTTER
(EXCEPT 47 SERIES)
335
360
331
339
337
340
335
360
331
339
337
340
ROTOR/SHUTTER
47 SERIES ONLY
322
–
–
323
–
325
OPTIONAL ACCESSORIES FOR THE
UNILITE
®
DISTRIBUTOR
Active Power Filter . . . . . . . . . . . Part No. 29351
Helps prevent module failures due to voltage
spikes associated with “noisy” electrical systems
and electrical defects.
Advance Curve Change Kit. . . . . Part No. 29014
Required to change the amount and rate of
advance within a range of 14° to 28°. Includes
degree keys, springs, and instructions to plot
advance curves.
MARINE
(YLU SERIES ONLY)
8 CYL. (STACK CAP)
209D
8 CYL. (FLAT CAP)
221B
6 CYL. (SMALL HOUSING, 3.12" O.D.)
226B
6 CYL. (LARGE HOUSING, 3.65" O.D.)
270B
4 CYL. (SMALL HOUSING, 3.12" O.D.)
225B
4 CYL. (LARGE HOUSING, 3.65" O.D.)
271B
®
UNILITE MODULE, ALL MODELS: PART NO. 605
DISTRIBUTOR WIRE HARNESS, ALL MODELS: PART NO. 29349
MALLORY IS A DIVISION OF THE MR. GASKET PERFORMANCE GROUP
10601 MEMPHIS AVE. #12, CLEVELAND, OH 44144
216.688.8300
FAX 216.688.8306
FORM 1214M
(REV. J) 09/03
Made in U.S.A.
Printed in U.S.A.
MALLORY [ MALLORY PERFORMANCE CLUB ]
