NOTE: All part numbers
are RoHS Compliant
AMP M Series
Pin and Socket Connectors
Special Application Connectors
Special Application
Connectors are available in
the following configurations:
V.35
Shallow Block
High Current
Mixed
High Voltage
RFI/EMI Shielded
Grounding Blocks
housing. Housings are avail-
able in 15-, 16-, 29 CF
(center fastener) and
42-position sizes and,
depending upon the specific
configuration, will accept
Multimate contacts, Type I
and Miniature, Standard and
Twin Standard COAXICON
contacts. The rectangular
contact cavities accept
Type XII contacts.
Grounding blocks are
ideally suited for aircraft appli-
cations, where shielded cable
is to be grounded to an air-
frame. The ground wires of
shielded cables are pigtailed
off with ferrules and are
crimped to Size 16 socket con-
tacts. The contacts are loaded
into a standard 14- or 34-posi-
tion connector housing. This
connector then can be mated
to the grounding block which
is fastened to the aircraft
frame. Grounding blocks have
Size 16 screw-machined pin
contacts which are staked, riv-
eted and soldered into the
L-shaped metal bracket. The
bracket has fixed jackscrew
receptacles that will accept
the special turnable jack-
V.35 Connector
The 34 position V.35
High voltage connectors are
designed for high voltage
applications using Multimate
contacts. The cavity centerline
spacings and the silo con-
struction of the contact
cavities increase the current
creepage path for higher volt-
age ratings. Housing sizes
include 20 and 28 positions.
Connector is fully assembled
and ready for placement on a
printed circuit board. They are
also available in kit form for
cable assembly. These
AMP V.35 connectors meet
the requirements of 408-2593
for CCITT V.35 interfacing.
High current connectors are
designed for applications
requiring up to 25 amperes of
current. They are available in
12-position male and female
housings which have rectan-
gular contact cavities for
screws fastened to the mating
socket connector half.
RFI/EMI shielding kits
provide shielding capabilities
against radio frequency and
electromagnetic interferences.
Special 104-position housings
accept Multimate contacts
and are especially designed
for use with shielding hard-
ware. These shielding kits
cannot be used with the
standard 104-position
accepting Type XII contacts.
Mixed connectors are
designed for applications that
require intermixing signal,
power and/or coaxial circuits
in the same connector
connector housings.
61
Catalog 82003
Revised 06-08
Dimensions are in millimeters
and inches unless otherwise
specified. Values in brackets are
Dimensions are shown for USA: 1-800-522-6752
reference purposes only. Canada: 1-905-470-4425
South America: 55-11-3611-1514
Hong Kong: 852-2735-1628
Japan: 81-44-844-8013
Specifications subject
Mexico: 01-800-733-8926
www.tycoelectronics.com equivalent U.S. Customary Units. to change.
C. America: 52-55-5-729-0425 UK: 44-141-810-8967
MACOM [ Tyco Electronics ]
