LTC1446/LTC1446L
DEFI ITIO S
Resolution (n)
Resolution is defined as the number of digital input bits,
n. It defines the number of DAC output states (2
n
) that
divide the full-scale range. The resolution does not imply
linearity.
Full-Scale Voltage (V
FS
)
This is the output of the DAC when all bits are set to one.
Voltage Offset Error (V
OS
)
The theoretical voltage at the output when the DAC is
loaded with all zeros. The output amplifier can have a true
negative offset, but because the part is operated from a
single supply, the output cannot go below zero. If the
offset is negative, the output will remain near 0V resulting
in the transfer curve shown in Figure 1.
OUTPUT
VOLTAGE
NEGATIVE
OFFSET
Figure 1. Effect of Negative Offset
The offset of the part is measured at the code that corre-
sponds to the maximum offset specification:
V
OS
= V
OUT
– [(Code)(V
FS
)/(2
n
– 1)]
Least Significant Bit (LSB)
One LSB is the ideal voltage difference between two
successive codes.
LSB = (V
FS
– V
OS
)/(2
n
– 1) = (V
FS
– V
OS
)/4095
U
U
Nominal LSBs:
LTC1446 LSB = 4.095V/4095 = 1mV
LTC1446L LSB = 2.5V/4095 = 0.610mV
Zero Scale Error (ZSE)
The output voltage when the DAC is loaded with all zeros.
Since this is a single supply part this value cannot be less
than 0V.
Integral Nonlinearity (INL)
End-point INL is the maximum deviation from a straight
line passing through the end points of the DAC transfer
curve. Because the part operates from a single supply and
the output cannot go below 0, the linearity is measured
between full scale and the code corresponding to the
maximum offset specification. The INL error at a given
input code is calculated as follows :
INL = [V
OUT
– V
OS
– (V
FS
– V
OS
)(Code/4095)]/LSB
DAC CODE
1446/46L F01
0V
V
OUT
= the output voltage of the DAC measured at the given
input code
Differential Nonlinearity (DNL)
DNL is the difference between the measured change and
the ideal 1LSB change between any two adjacent codes.
The DNL error between any two codes is calculated as
follows:
DNL = (∆V
OUT
– LSB)/LSB
∆V
OUT
= The measured voltage difference between two
adjacent codes
7
LINER [ LINEAR TECHNOLOGY ]
