45 | Keysight | FieldFox Handheld Analyzers 4/6.5/9/14/18/26.5/32/44/50 GHz - Data Sheet
General Information (continued)
EMC: Complies with the essential requirements of the European EMC Directive as well as current editions of the following standards (dates and editions
are cited in the Declaration of Conformity):
IEC/EN 61326–1
CISPR Pub 11 Group 1, class B
AS/NZS CISPR 11
ICES/NMB–001
This ISM device complies with Canadian ICES-001.
Cet appareil ISM est conforme a la norme NMB-001 du Canada.
SAFETY: Complies with the essential requirements of the European Low Voltage Directive as well as current editions of the following standards (dates and
editions are cited in the Declaration of Conformity):
IEC/EN 61010-1
Canada: CSA C22.2 No. 61010-1
USA: UL std no. 61010-1
To find a current Declaration of Conformity for a specific Keysight product, go to: http://www.keysight.com/go/conformity
Explosive environment
This product has been type tested to meet the requirements for operation in explosive environments in
accordance with MIL-STD-810G, Method 511.5, Procedure I.
Power supply
External DC input
External AC power adapter
Input
15 to 19 VDC, 40 watts maximum when battery charging
Efficiency level IV
100 to 250 VAC, 50 to 60 Hz, 1.25 to 0.56 A
15 VDC, 4 A
Output
Power consumption
Battery
14 watts typical, mode dependent
Lithium ion
10.8 V, 4.6 A-h
Operating time
3.5 hours (typical), mode dependent
Charge time
A fully discharged battery takes about 1.5 hours to recharge to 80%. Four hours to 100%.
Discharge temperature limits
Charge temperature limits
Storage temperature limits
—10 to 60 ºC, ≤ 85% RH
0 to 45 ºC, ≤ 85% RH
—20 to 50 ºC, ≤ 85 % RH
The battery packs should be stored in an environment with low humidity. Extended exposure to
temperature above 45 ºC could degrade battery performance and life.
Test port connectors
≤ 18 GHz models
26.5 GHz models
Type-N (f)
3.5 mm (m) for FieldFox microwave analyzer, N9918A and FieldFox microwave VNA analyzer, N9928A.
On FieldFox SA N9938A, you may choose 3.5 mm (m) or Type-N (f). Type-N (f) port connector is not
available for the 26.5 GHz microwave analyzer, N9918A or 26.5 GHz microwave VNA analyzer, N9928A
≥ 32 GHz models
NMD 2.4mm (m), torque .9 Nm or 8 in-lb, use torque wrench N9910X-886
Display
6.5” transflective color VGA-LED backlit
Headphone jack connector
3.5 mm (1/8 inch) miniature audio jack