22 | Keysight | Infiniium 90000 Series Oscilloscopes - Data Sheet
InfiniiMax II: The World’s Best High-Speed Probing System Just Keeps Getting Better
InfiniiMax offers you the highest
performance
A flat frequency response
over the entire probe bandwidth eliminates
the distortion and frequency-dependent
loading effects that are present in probes
that have an in-band resonance�
available for measuring differential
and single-ended signals, with flexible
connectivity solutions for today’s high-
density ICs and circuit boards�
E2695A 8-GHz differential SMA
probe head
InfiniiMax probes have fully
characterized performance
allows you to connect two SMA cables
to make a differential measurement on a
single scope channel�
for all of their various probe heads� This
includes:
– Swept frequency response plot
– Common mode rejection versus
frequency plot
– Impedance versus frequency plot
– Time-domain probe loading plot
– Time-domain probe tracking plot
E2679A 6-GHz extremely small
single-ended, solder-in probe
heads
for probing even the hardest-to-reach
single-ended signals�
Controlled impedance
transmission lines in every probe
head deliver full performance
N5425A 13-GHz high-bandwidth
solder-in differential ZIF probe
head
versus the performance limitations
and N5426A ZIF tip provides maximum
bandwidth with the industry’s first
introduced by traditional wire accessories�
lead-free solder-in probe solution in an
economical replaceable tip form factor�
Probe interface software
allows you to save the calibration
information for up to 10 different probe
heads per channel and will automatically
retrieve calibration data for a probe
amplifier when attached to the scope�
N5451A 9-GHz/5-GHz
long-wire ZIF tip
provides a high-bandwidth economical
replaceable solder-in tip with extra reach
(9 GHz with 7 mm and 5 GHz with 11 mm
wire)�
High-input impedance active
probes
minimize loading, support differential
measurements and DC offset, and can
compensate for cable loss�
N5451A 9-GHz/5-GHz
long-wire ZIF tip
N5426A
provides a high-bandwidth economical
replaceable solder-in tip with extra reach
(9 GHz with 7 mm and 5 GHz with 11 mm
wire)�
Probe calibration software
delivers the most accurate probe
measurements and linear phase response
and allows various probe combinations to
be deskewed to the same reference time�
E2695A 8-GHz differential SMA
probe head
N5451A
allows you to connect two SMA cables
to make a differential measurement on a
single scope channel�