08 | Keysight | N5393D PCI Express® 3.0 (Gen3) Software for Infiniium Oscilloscopes - Data Sheet
Configurability and Guided Connections
The PCI Express electrical test software
provides flexibility in your test setup. It
guides you to make connection changes
with hookup diagrams when the tests you
select require it. All PCI Express electrical
compliance tests you perform are based
on the official PCI-SIG approved set of test
fixtures. The compliance fixtures include
the Compliance Base Board (CBB2) for
add-in card testing, and the Compliance
Load Board (CLB2) for motherboard
or system testing. Connection to the
compliance test fixtures is selectable
between SMA/SMP cables or Keysight
InfiniiMax active differential probes.
Specify 1 million UI (or
more) for your jitter
measurements
Show the spectral
response of your
reference clock in the
critical 1.5 to 22-MHz
region
Figure 6. In configuring the tests, you specify the device to test, its configuration, and how the
oscilloscope is connected.
If more than one test setup connection
is required, you will be notified here
You are prompted to make the appropriate
connections for the set of tests
Toggle circuit to switch between Gen1
(2.5 GBit/s) and Gen2 (50 GBit/s)
Figure 7. When you make multiple tests where the connections must
be changed, you are prompted with connection diagrams and/or
photographs.
Figure 8. The PCI-SIG Compliance Base Board (CBB2) for Gen2
add-in card testing, and the Compliance Load Board (CLB2) for Gen2
motherboard or host system testing.