PICKING TOOLS
The MS763 sensors have a membrane size of 0.5 x 0.5 mm and outer dimensions of 1,3 x 2.2 mm. The pick
and place tool has to be of a soft material as rubber (Hardness 78-97 Shore A). Its external size must fit the
sensor and the vacuum cavity must be as large as the membrane itself. Successful tests were done with some
tools of SPT (see SPT drawing and references below).
SPT references
External dimension
Internal dimensions
RTR-A1-060x060
TL & TW: 0.06 inch /1.52 mm
∅H: 0.035 inch / 0.89 mm
ORDERING INFORMATION
Product Code
type
Product
Art.-Nr.
76325022
76325221
MS763-A
MS763-S
Absolute
300 mmHg Pressure Sensor 0.2 mm Pyrex sawn on b/f
300 mmHg Pressure Sensor sawn on b/f
Differential
The MS763 dice are supplied sawn on blue foil, mounted on plastic rings
FACTORY CONTACTS
Intersema Sensoric SA
Ch. Chapons-des-Prés 11
CH-2022 BEVAIX
Tel. 032 847 9550
Tel. Int. +41 32 847 9550
Telefax +41 32 847 9569
e-mail:
SWITZERLAND
http://www.intersema.ch
NOTICE
Intersema reserves the right to make changes to the products contained in this data sheet in order to improve the design or performance
and to supply the best possible products. Intersema assumes no responsibility for the use of any circuits shown in this data sheet, conveys
no license under any patent or other rights unless otherwise specified in this data sheet, and makes no claim that the circuits are free from
patent infringement. Applications for any devices shown in this data sheet are for illustration only and Intersema makes no claim or
warranty that such applications will be suitable for the use specified without further testing or modification.
DA763_002.doc
00007631360
ECN 1147
October 9, 2008
4/4