Fast Ethernet 10/100 Quad Transceivers — LXT974/LXT975
Table 4. LXT975 Signal Detect/TP Select Signal Descriptions
Pin#2
Symbol
Type1
Signal Description
Signal Detect - Ports 1 & 3. When SD/TPn pins are tied High or to a 5V PECL input, bit
19.2 = 1 and the operating mode of each respective port is forced to FX mode. In this
mode, full-duplex is set via pin 117 (FDE_FX). When not using fiber mode, SD/TPn pins
should be tied to GNDT.
TP Select - Ports 1 & 3. When SD/TPn pins are tied Low, bit 19.2 = 0. The operating mode
of each port can be set to 10BASE-T, 100BASE-TX, or 100BASE-FX via the hardware
control interface pins as shown in Table 8 on page 16.
149
130
SD1/TP1
SD3/TP3
I
Note: Hardware control interface pins (CFG_0, CFG_1, CFG_2, FDE, BYPSCR, and
AUTOENA) are global and set all ports simultaneously.
In TP mode, network pins operate as described in Table 5.
In FX mode, network pins are re-mapped and operate as described in Table 6.
1. Type Column Coding: I = Input, O = Output.
2. When not using fiber mode, SD/TPn pins should be tied to GNDT.
Table 5. LXT975 Twisted-Pair Interface Signal Descriptions
Pin#
Symbol
Type1
Signal Description
155, 152
145, 148
136, 133
126, 129
TPOP0, TPON0
TPOP1, TPON1
TPOP2, TPON2
TPOP3, TPON3
Twisted-Pair Outputs, Positive & Negative - Ports 0-3.
O
During 100BASE-TX or 10BASE-T operation, TPO pins drive 802.3 compliant
pulses onto the line.
158, 157
142, 143
139, 138
123, 124
TPIP0, TPIN0
TPIP1, TPIN1
TPIP2, TPIN2
TPIP3, TPIN3
Twisted-Pair Inputs, Positive & Negative - Ports 0-3.
I
During 100BASE-TX or 10BASE-T operation, TPI pins receive differential
100BASE-TX or 10BASE-T signals from the line.
1. Type Column Coding: I = Input, O = Output.
Table 6. LXT975 Fiber Interface Signal Descriptions
Pin#
Symbol
Type1
Signal Description
Fiber Network Interface - Ports 1 and 3
145, 148
126, 129
FIBIN1, FIBIP1
FIBIN3, FIBIP3
I
During 100BASE-FX operation, FIBI pins receive differential PECL inputs
from fiber transceivers.
Fiber Network Interface - Ports 1 and 3
142, 143
123, 124
FIBOP1, FIBON1
FIBOP3, FIBON3
O
During 100BASE-FX operation, FIBO pins produce differential PECL
outputs for fiber transceivers.
1. Type Column Coding: I = Input, O = Output.
Datasheet
13